00198442-04_UM_TX-V2_EN.pdf - 第35页
Instruction manual SIPLACE TX 2 Operational safety From software version 714.0 12/2020 2.1 Safety instructions 35 2 Operational safety 2.1 Safety instructions 2.1.1 Conventions for the use of hazard symbols This manual c…
1 Introduction Instruction manual SIPLACE TX
1.7 Operator levels From software version 714.0 12/2020
34
Instruction manual SIPLACE TX 2 Operational safety
From software version 714.0 12/2020 2.1 Safety instructions
35
2 Operational safety
2.1 Safety instructions
2.1.1 Conventions for the use of hazard symbols
This manual contains notes that must be observed to guarantee your personal safety and to avoid
damage to equipment. These notes are highlighted by warning triangles and are indicated as fol-
lows according to the level of risk:
2
2
2
2
DANGER
Definition
Danger, as used in this manual, means that death, severe injury or considerable damage
to equipment will occur if the danger instructions are not followed.
WARNING
Definition
Warning, as used in this manual, means that death, severe injury or considerable dam-
age to equipment may occur if the warning instructions are not followed.
CAUTION
Definition
Caution, as used in this manual, means that slight injury or damage to equipment may
occur if the caution instructions are not followed.
PLEASE NOTE
Definition
A note, as used in this manual, provides information on the product or indicates a part of
the manual that requires particular attention.
2 Operational safety Instruction manual SIPLACE TX
2.1 Safety instructions From software version 714.0 12/2020
36
2.1.2 Qualified personnel
Qualified or adequately trained personnel means that these people are familiar with the setting up,
operation and preventive maintenance of placement machines and add-on devices and are suit-
ably qualified, e.g.
– have been trained, instructed or authorized to switch on and off, isolate, earth and identify
electrical circuits and system components in accordance with normal safety standards.
– have been trained or instructed in the upkeep and use of appropriate safety equipment in ac-
cordance with normal safety standards.
2.1.3 Important notes on operational safety
The following points MUST be observed in order to maintain operational safety:
2.1.3.1 General
The operational safety of SIPLACE placement machines can only be guaranteed if the place-
ment machine is used as prescribed and in accordance with the instructions in the instruction/
preventive maintenance manuals (job cards).
Always follow any safety regulations specific to your country.
Make sure that the warning labels are always clearly identifiable and always easily readable.
Replace any damaged warning or notice labels. Replace any labels that are missing.
The machine key for releasing the covers on the placement machine must be kept in a safe
place where it is only accessible to qualified staff!
2
If it is necessary to work on the machine and you do not have adequately trained personnel
within your operation, always call in a ASM Assembly Systems GmbH&Co.KG service engi-
neer! ASM Assembly Systems GmbH&Co.KG will not accept liability for any damage or con-
sequential damage that is the result of unauthorized/incorrect work.
PLEASE NOTE
Owner's responsibility
The machine owner, and only the machine owner, is responsible for the safekeeping of
the machine key and for ensuring that it is handed over to authorized persons.