00198442-04_UM_TX-V2_EN.pdf - 第269页
Instruction manual SIPLACE TX 6 Station exte nsions From software version 714.0 12/2020 6.1 Nozzle changer 269 6 S t ation extensions For the relevant configuration s and other option s, refer to the individual specifica…
5 Tasks at the placement machine Instruction manual SIPLACE TX
5.14 Docking the component trolley in or out From software version 714.0 12/2020
268
5.14.3 Safety instructions for moving the component trolley
5
Always hold the handles with both hands when you want to move the component trolley.
Remember that a component trolley with the full complement of feeder modules can tip over
sideways or forward on gradients of 20° or more.
Make sure that the surface on which the trolley is moved has a significantly smaller gradient.
Be careful not to collide with obstacles. The trolley could tip forward if it is traveling fast
enough.
5.14.4 Docking out the component trolley
Switch the control system "Off".
Press the button on the respective placement machine location until the component trolley is
completely undocked.
With both hands on the handles, pull the component trolley out of the placement machine.
WARNING
Avoid accidents!
To prevent accidents, ALWAYS follow the rules listed below when you move the compo-
nent trolley.
Instruction manual SIPLACE TX 6 Station extensions
From software version 714.0 12/2020 6.1 Nozzle changer
269
6 Station extensions
For the relevant configurations and other options, refer to the individual specifications for the SI-
PLACE placement machines.
6.1 Nozzle changer
The nozzle changer is available in two variants for the relevant head type:
– Short nozzle changer with 4 magazines and 20 nozzle garages each for the SIPLACE TX1 /
TX2 / TX2 m
– Narrow nozzle changer with 3 magazines and 20 nozzle garages each for the
SIPLACE TX2i /TX2i m / TX2i m 4 mm
The magazines are seated on a common support. They are centered with two parallel pins and
fixed in place with 4 push buttons. The exact position is determined with two fiducials on each
magazine. The correct seat of the magazines on the basic nozzle changer body is monitored by
microswitches, to prevent a collision of the placement head with any magazines projecting up-
wards. All magazine locations must be filled since the safety circuit stops the placement machine
in response to missing magazines or magazines that are not seated correctly. At the installed noz-
zle station, components can be blown off the nozzles of the SpeedStar and nozzles stripped off
and rejected.
6 Station extensions Instruction manual SIPLACE TX
6.1 Nozzle changer From software version 714.0 12/2020
270
6.1.1 SIPLACE SpeedStar C&P20 P2 /C&P20 M3 nozzle changer
6.1.1.1 Short nozzle changer with 4 magazines
The short nozzle changer with 4 magazines is used with the SIPLACE TX1/2.
Item no. 03103649-xx Nozzle changer basic assembly CP/all - short
Item no. 03101503-xx Nozzle magazine 60xx/40xx with 20 garages
6
Fig. 6.1 - 1 Short nozzle changer for the SIPLACE SpeedStar with 4 magazines
6
CAUTION
Only use this nozzle magazine together with the SpeedStar.