Installationsanleitung_SuSE9.3_en.pdf - 第50页

Installation Description Customized LRL SuSE 9.3 • Activate USB support in t he BIOS (computer-dependent 2 ) 4.5.2.2.2 Installation procedure 1. Log into the line computer under GNOME as the user " plr ". 2. Co…

100%1 / 69
Customized LRL SuSE 9.3 Installation Description
Figure 4-12
24. Exit the printer configuration by clicking the "Finish" button.
25. A message is displayed indicating that the settings will be saved.
Figure 4-13
26. Confirm the message with "Yes", otherwise the data specified will not be saved.
27. A message appears indicating that the data has been saved successfully.
Figure 4-14
28. Confirm the message by clicking "OK".
29. Finally, exit the "YaST2 Control Center" by clicking "Close".
30. You can now use the configured printer. It is not necessary to restart the line computer.
4.5.2.2 Local installation on the USB port under SuSE 9.0 / SuSE 9.3
4.5.2.2.1 Requirements
• Installed software "SIPLACE auteq-LINUX based on SuSE 9.0" or
• Installed software "SIPLACE auteq-LINUX based on SuSE 9.3".
• PC with USB port.
49 of 69
Installation Description Customized LRL SuSE 9.3
• Activate USB support in the BIOS (computer-dependent
2
)
4.5.2.2.2 Installation procedure
1. Log into the line computer under GNOME as the user "plr".
2. Connect the printer to the USB port of the computer.
3. Switch on the printer.
4. Open a terminal window by selecting "Operating system level" from the "Options" menu.
5. Enter the commands
su -c yast2
(and enter the "root" password) to start the "YaST Control Center" configuration tool.
Figure 4-15
50 of 69
2
e.g. System "Primergy Econel 20":
"Advanced" page
Entry "Advanced System Configuration"
Entry "USB Host Controller:" must have the value "Enabled"
Customized LRL SuSE 9.3 Installation Description
6. On the left, select the "Hardware" menu and then select the "Printer" function on the right.
Figure 4-16
7. Under normal circumstances, the printer type is detected automatically. You can then change the
settings by clicking the "Configure" button and continue at point Fehler! Verweisquelle konnte
nicht gefunden werden..
Figure 4-17
51 of 69