00195760-0102_UM_D3_SR605_EN.pdf - 第166页
3 Technical data for the machine User Manual SIPLACE D3 3.10 Component trolley From software version SR.605.xx 07/2008 EN Edition 166 PLEASE NOTE: At external set-up positions, you will need an ex ternal power supply for…
User Manual SIPLACE D3 3 Technical data for the machine
From software version SR.605.xx 07/2008 EN Edition 3.10 Component trolley
165
3.10 Component trolley
Item no. 00119622-xx Component trolley, SIPLACE HF/X/D3
Up to four component trolleys can be docked into the machine. The locations are numbered as
shown in the diagram below.
3
Fig. 3.10 - 1 Locations for the component trolleys
(1) Location 1
(2) Location 2
(3) Location 3
(4) Location 4
(T) PCB direction of travel
The component trolleys are stand-alone modules that can be set up with feeders at an external
set-up area. This means that the production process only has to be interrupted briefly in order to
change the component trolley.
3 Technical data for the machine User Manual SIPLACE D3
3.10 Component trolley From software version SR.605.xx 07/2008 EN Edition
166
PLEASE NOTE:
At external set-up positions, you will need an external power supply for the component trolley
(see Section 3.10.6, page 171).
3
Fig. 3.10 - 2 Component trolley with a PCB conveyor height of 950 mm
3
(1) Holes in the guide columns for the conveyor heights of 830 to 950 mm
(2) Component trolley table
3.10.1 Structure
The component trolley essentially consists of the chassis, the component table for holding the
feeder modules, the communication unit, tape reel container and the waste container.
User Manual SIPLACE D3 3 Technical data for the machine
From software version SR.605.xx 07/2008 EN Edition 3.10 Component trolley
167
3
Fig. 3.10 - 3 Component trolley: front and back view
(1) Chassis
(2) Component table
(3) Communication unit
(4) Tape reel container
(5) Waste tape container
(6) Interface for the main power supply, communication, the safety circuit and the compressed
air supply for the bulk case feeder module
(7) Handle
(8) Hand guard
3
3
3.10.2 Description
The chassis (item 1 in Fig. 3.10 - 3, page 167) runs smoothly and is easy to maneuver.
The handles (item 7 in Fig. 3.10 - 3
, page 167) can be folded up or down.
The component table (item 2 in Fig. 3.10 - 3
, page 167) has a capacity of up to 15 locations for 30
mm wide feeder modules. The feeder modules are mechanically centered on the table using cen-
tering pins and centering balls. The feeder modules are supplied with compressed air via a sepa-
rate compressed air bar.
The interface for the power module, communication and safety circuits (item 6) is beneath the
component feeder table bed. The compressed air supply for bulk case feeder modules also
passes via this interface.