00195760-0102_UM_D3_SR605_EN.pdf - 第285页

User Manual SIPLACE D3 6 Station extensions From software version SR.605.xx 07/2008 EN Edition 6.1 Nozzle changer 285 6.1.1.5 Notes on operation → When you fill a magazine with a certain nozzle ty pe for the first time, …

6 Station extensions User Manual SIPLACE D3

6.1 Nozzle changer From software version SR.605.xx 07/2008 EN Edition

284

6.1.1.4 Assembly

"Row 1" nozzle changers (see Fig. 6.1 - 2, page 283) are each fixed to the component trolley dock-

ing unit. There is an additional assembly kit for the "row 2" nozzle changer. This kit consists of the

take-off device and the nozzle reject bin (see Section 6.1.1.8

, page 288).

Fig. 6.1 - 3 Assembly position

(1) Spring hook pointing toward the operator

(2) Retaining clamp pointing toward the PCB conveyor

→ Align the nozzle changer so that the moving spring hooks always point toward the operator,

while the retaining clamps always point toward the PCB conveyor.

WARNING 6

Only install the associated nozzle changer for each placement head. There is a risk of head

crashes with mixed configurations.

User Manual SIPLACE D3 6 Station extensions

From software version SR.605.xx 07/2008 EN Edition 6.1 Nozzle changer

285

6.1.1.5 Notes on operation

→ When you fill a magazine with a certain nozzle type for the first time, attach an adhesive label

to identify the type.

PLEASE NOTE 6

Fill the magazines off the machine and always replace complete magazines. 6

→ Open the locking plate and place the nozzles in the nozzle holders.

→ Close the locking plate so that the nozzles cannot drop out of the magazines.

CAUTION 6

Before you fill magazine, make sure that all the nozzles on the Collect&Place head have

been returned to their magazines. 6

→ Programming the nozzle changer is described in the SIPLACE Pro user manual.

PLEASE NOTE 6

→ Do not allow components to drop onto the magazines. If they do, they could jam the locking

plate.

→ Do not allow components to drop onto free feeder module locations. They will stick to the

magnetic bar. Production may have to be interrupted if the feeder modules are not placed on

the component table correctly. You should therefore regularly clean the magazines and free

locations.

6 Station extensions User Manual SIPLACE D3

6.1 Nozzle changer From software version SR.605.xx 07/2008 EN Edition

286

6.1.1.6 Changing the magazine

→ To remove the magazine, push the spring hook (item 1 in Fig. 6.1 - 4) away from the maga-

zine. Lift the magazine out of the carrier.

Fig. 6.1 - 4 Changing the magazine

(1) Spring hook

(2) Retaining clamp

(3) Centering hole

(4) Slot

(A) Push the spring hook away from the magazine