00195760-0102_UM_D3_SR605_EN.pdf - 第280页

5 Tasks for the operating personnel User Manual SIPLACE D3 5.10 Docking the component trolley in or out From software version SR.605.xx 07/2008 EN Edition 280 5 Fig. 5.10 - 3 Component trolley - swivel handles down (1) P…

User Manual SIPLACE D3 5 Tasks for the operating personnel

From software version SR.605.xx 07/2008 EN Edition 5.10 Docking the component trolley in or out

279

→ Always hold the handles with both hands when you want to move the component trolley.

→ Remember that a component trolley with the full complement of feeder modules can tip over

sideways or forward on gradients of 20° or more.

→ Make sure that the surface on which the trolley is moved has a significantly smaller gradient.

→ Be careful not to collide with obstacles. The trolley could tip forward if it is traveling fast

enough.

5.10.4 Docking in the component trolley

PLEASE NOTE

Shorten the component tapes on the front end of the S feeder modules to approximately 1 cm

before you dock in the component trolley.

CAUTION

Check that the placement head is outside the range of the component trolley.

→ Carefully push the component trolley into machine as far as the stop.

PLEASE NOTE

Close the protective covers since the component trolley can only be docked in if the covers are

closed.

→ Press the relevant button on the input or output side of the machine (item 1, 2, 3 or 4 in Fig.

5.10 - 1

, page 277), until the trolley is docked in fully.

→ Push the sleeve (item 1 in Fig. 5.10 - 3

, page 280) up using both handles and swivel the han-

dle down (item 2 in Fig. 5.10 - 3

, page 280).

5 Tasks for the operating personnel User Manual SIPLACE D3

5.10 Docking the component trolley in or out From software version SR.605.xx 07/2008 EN Edition

280

Fig. 5.10 - 3 Component trolley - swivel handles down

(1) Push sleeve up

(2) Fold handle down

User Manual SIPLACE D3 6 Station extensions

From software version SR.605.xx 07/2008 EN Edition 6.1 Nozzle changer

281

6 Station extensions

6.1 Nozzle changer

Nozzle changers can greatly increase the flexibility of the placement heads for processing differ-

ent types of component. If the placement program requires a nozzle change, then the placement

head automatically returns the old nozzle to the nozzle holder and picks up the new nozzle. Noz-

zles that were separated out during the vacuum check can also be quickly changed.

It is significantly more exact and faster to pick up nozzles from a nozzle changer than would be

possible manually. When placing small components, it is essential to minimize the radial eccen-

tricity during nozzle rotation.

6.1.1 Nozzle changer for the 12-segment Collect&Place head

Item no. 00119661-xx Nozzle changer HF/X/D3, 12-segment C&P head

Fig. 6.1 - 1 Nozzle changer for the 12-segment Collect&Place head