MEC-CP842-1.0E.pdf - 第104页

Maintena nce >> Lubrication 5-44 MEC-CP842-1.0E 5.2.20 Lubricating the Cam Lever Air Cylinder Procedure 1 Open the lid of the lu bricator with a blade screwdriver . 2 Lower the lubricat or cover . 3 V isually check…

100%1 / 232
Maintenance >> Lubrication
MEC-CP842-1.0E 5-43
12 Slowly pour the new oil into the inlet on the top of the oil cooler.
13 Ensure that the oil volume is in the range specified by the level indicator.
Note: However, does not normally change. Immediately after replacement, the oil level will drop
when the machine is run. Run the machine for a short time, and then add more oil until the
level is within the recommended range. The oil level indicator should remain at the same
position with the machine off as it is when running.
C746M3036
(51)
<CP-842E> <CP-842ME>
Oil range
Oil cooler
Gauge glass
Level indicator
Cap
Oil inlet
Maintenance >> Lubrication
5-44 MEC-CP842-1.0E
5.2.20 Lubricating the Cam Lever Air Cylinder
Procedure
1 Open the lid of the lubricator with a blade screwdriver.
2 Lower the lubricator cover.
3 Visually check the oil level of the oil tank and slowly pour in the oil to the lubri-
cator. Do not to exceed the upper limit while pouring in the oil.
Note: The maximum amount of oil that can be supplied to the lubricator is 75 cc. If the oil level does
not reach the tip of the pipe inside the case, there will be insufficient oil to lubricate the cylin-
der.
4 Replace the lubricator cover and attach the oil inlet cap.
5 Check and discard of any waste oil in the collection bottle.
C746M3T18
52
Turbine oil + NASKALUBE (*) Every 6 months
Lubrication points
Schedule
Types of lubricant
Air cylinder
(*) This lubricant is a unique blend of oil (Turbine oil + NASKALUBE) available only
from Fuji.
A
A
B
B
C746M3037
Cam lever air cylinder
(52)
Case
Cover
Bottle
Lubricator
Lid
Upper limit
Pipe
Lower limit
Maintenance >> Lubrication
MEC-CP842-1.0E 5-45
5.2.21 Lubricating the Rotary Holder Positioning
Pins
The arrow in the diagram indicates the lubrication point. Apply grease with the
positioning pin pushed in.
C746M3T22E
.WDTKECVKQPRQKPVU
53
AFC grease /QPVJN[
5EJGFWNG
6[RGUQHNWDTKECPV
4QVCT[JQNFGTRQUKVKQPKPIRKP
5RGEKCNPQ\\NG
(KVVKPI
6WDG
5[TKPIG
%QPPGEVVJGU[TKPIG(S2184A), tube (DGPJ6000), fitting (WPJ1261),
and NY-axis special nozzle to apply grease.
C84PHD003E
2WUJKPVJGRQUKVKQPKPIRKP
YJGPCRRN[KPIITGCUG