MEC-CP842-1.0E.pdf - 第69页

Maintenance >> Cleaning MEC-CP842-1.0E 5-9 Next remove the filter case and clean the filter element. 4 Disconnect the drain hose from the regulator i f one is used. 5 Remove the filter case by rotating it while pre…

Maintenance >> Cleaning

5-8 MEC-CP842-1.0E

5.1.7 Filter Regulator (Weekly)

Point

The air that flows through the system’s air lines should always be clean. A dirty filter

regulator makes it impossible to supply clean air, and can cause equipment failure.

Procedure

Be sure to turn the air supply off and to release the air pressure in advance.

1 Close the air inlet valve lever and cut the external air-supply.

2 Reduce the pressure in the air hose.

After disconnecting the air hose, return the valve lever slowly to the position

indicated in the illustration below to expel the air from the air inlet.

3 Close the valve lever again when the air has been fully expelled.

CAUTION

Turn the main power off before performing this procedure.

C746M3006

Valve lever

C746M3007

Valve lever

Air

Air hose

Maintenance >> Cleaning

MEC-CP842-1.0E 5-9

Next remove the filter case and clean the filter element.

4 Disconnect the drain hose from the regulator if one is used.

5 Remove the filter case by rotating it while pressing the lock down.

6 Remove any drainage collected in the filter case and wash the case with neutral

detergent.

7 Remove and clean the element.

Note: The element should be replaced every 2 years.

Assemble the filter regulator after cleaning, attach the air-hose, and open the valve

lever.

C746M3008

Filter regulator

AW3000-02-BD

Mist separator

AFM3000-02-D

O-ring

Lock knob Lock knob

Filter case

Model : 111585

Manufacturer : SMC

Filter element

Model : 630617

Manufacturer : SMC

Element assemby

Maintenance >> Cleaning

5-10 MEC-CP842-1.0E

5.1.8 Machine Interior (Weekly)

Point

Chip parts and other foreign objects will accumulate in the machine during operation.

Such objects should be removed from the machine to keep the machine in good work-

ing order.

Procedure

1 Use a vacuum cleaner to remove the foreign objects from the machine interior.

2 Use a dry cloth to wipe grease off of all areas that do not require lubrication.

Caution:Do not use an air blower to clean the machine interior because dust or small objects may be

blown into and damage other areas of the machine.

WARNING

Turn the main power off before performing this procedure.