MEC-CP842-1.0E.pdf - 第76页

Maintena nce >> Cleaning 5-16 MEC-CP842-1.0E 5.1.14 Carrier Rodless Cylinder (Monthly) Point Scattered chips, dust, and fine fibers adhere to the slide su rface of the rodless cyli nder used to drive the carrier . …

Maintenance >> Cleaning

MEC-CP842-1.0E 5-15

5.1.13 Oil Cooler Air Filter (Monthly)

Point

An air filter is attached to the exterior of the oil cooler unit. This filter should be

cleaned periodically to prevent damage to the oil cooler unit.

Procedure

1 Remove the acrylic cover from the top of the machine.

2 Hold the tab and lift the filter upwards to remove.

3 Clean the filter with a vacuum cleaner.

WARNING

Turn the main power off before performing this procedure.

C746M3012

<CP-842E> <CP-842ME>

Filter

Tab

Acrylic coverAcrylic cover

Maintenance >> Cleaning

5-16 MEC-CP842-1.0E

5.1.14 Carrier Rodless Cylinder (Monthly)

Point

Scattered chips, dust, and fine fibers adhere to the slide surface of the rodless cylinder

used to drive the carrier. As a result, it is necessary to perform periodic cleaning.

Procedure

1 Lightly wipe the slide surface of the rodless cylinder using a fine cloth. Remove

any dirt etc. that has accumulated between the ends of the slider surface and

the absorber holder.

2 Apply some grease to a fine cloth and wipe along the slider surface.

Note: Use Daphne Eponex No. 2 grease.

WARNING

Turn the main power off before performing this procedure.

C746M3013

Carrier cylinder

Absorber holder

Slider

Slide surface

Absorber holder

Maintenance >> Cleaning

MEC-CP842-1.0E 5-17

5.1.15 Nozzle Filter (Every 3 Months)

Point

The filter inside the shaft becomes dirty during the course of machine operation, and

should be replaced approximately every 3 months. If errors occur frequently for a spe-

cific nozzle, it is probable that the flow of air is being impeded by a dirty filter.

Procedure

1 Squeeze in the levers shown in the figure below, and carefully extract the filter.

Caution:

1. Do not apply excess force to the nozzle shaft.

2. Ensure that the filter is returned to the nozzle with the levers at the bottom.

2 Remove the pin from the filter assembly and replace both the filter and pin.

WARNING

Turn the main power off before performing this procedure.

C746M301

Filter Assy

C746M301

Filter