MEC-CP842-1.0E.pdf - 第55页

Basic Operat ion >> Sett ing the Feeders MEC-CP842-1.0E 4-5 4.3 Setting the Feeders Point Feeders must be set on the pallets in the corre ct manner in order for the nozzles to pick up parts. Refer to the CP Feeder …

Basic Operation >> Changing the Panel Back-up Pin Positions

4-4 MEC-CP842-1.0E

Snap the blocks into suitable lengths and use double-faced tape to stick them

to the back-up plate.

C746M2005

Rubber block

Basic Operation >> Setting the Feeders

MEC-CP842-1.0E 4-5

4.3 Setting the Feeders

Point

Feeders must be set on the pallets in the correct manner in order for the nozzles to

pick up parts. Refer to the CP Feeders Mechanical Reference (MEC-CPFDR-x.xE) for

additional details.

Procedure

1 Verify that the tape guide is not deformed.

2 Load the part tapes in the appropriate feeders. If a part tape is loaded in the

wrong feeder, then the tape guide may not close properly.

3 Insert the catch on the base of the feeder into the channel beneath the guide.

Push the feeder forward and then press the back of the feeder to clamp it firmly

in position.

WARNING

Press EMERGENCY STOP before performing this procedure.

C746M200

Correct Incorrect

C746M2007

Clampe

Guide channel

Feeder

Basic Operation >> Setting the Feeders

4-6 MEC-CP842-1.0E

13 and 15 inch parts reels should be positioned using the three rubber stoppers.

When setting, ensure that the feeder base and reel itself are positioned in the

same slot. Correct parts supply will not be possible if feeders are set incorrectly,

as shown in the figure below.

4 When setting a feeder on a device table, check for waste tape, etc. between the

feeder and the device table. Remove any foreign matter from the device table

grooves and the bottom of the feeder.

C746M2008

Reel holder

Rubber brace Rubber brace

Rubber brace

View of device table from above

C746M2009

Waste tape

Device table

Feeder