MEC-CP842-1.0E.pdf - 第61页

Maintenance >> Cleaning MEC-CP842-1.0E 5-1 5. Maintenance 5.1 Cleaning 5.1.1 W aste T ape Box a nd Filter (Every 8 Hours) Point W aste tape that is cut by the cutter is carri ed through a duct to the waste tape box…

Basic Operation >> Changing Pallets (CP-842ME option)

4-10 MEC-CP842-1.0E

Pallet Loading

1 Push the fork of the PCU (containing the replacement pallet) into the machine

and clamp it using the [Stage1 Clamp] command.

Caution:Exercise extreme care when using the PCU to move a fully loaded pallet. A dropped pallet

may result in serious injury or damage to the machine.

2 Push a pallet onto the machine’s D-axis.

3 Close the rear door and clamp the pallet at the D-axis.

Caution:

1. To avoid damage to the door stoppers, the door should be opened and closed with care.

2. If the rear door is closed as the pallet is being changed, the clamp will be activated even

though the pallet is not present.

4 Select the [Stage1 Set] command.

5 Select the [Stage1 Unclamp] command, then slowly retract the PCU. This com-

pletes the pallet change.

Maintenance >> Cleaning

MEC-CP842-1.0E 5-1

5. Maintenance

5.1 Cleaning

5.1.1 Waste Tape Box and Filter (Every 8 Hours)

Point

Waste tape that is cut by the cutter is carried through a duct to the waste tape box.

This box should be emptied after every 8 hours of operation.

Procedure

Open the door, remove the waste tape box, and empty the contents.

When emptying the waste tape box, also check the filter immediately above it. If the

filter is dirty, clean it with a vacuum cleaner.

Note: When cleaning is complete, ensure that the waste tape box and filter are inserted all the way

back to their original positions. Also, ensure that the door is properly closed.

C746M3001

Waste tape box

Filter

Maintenance >> Cleaning

5-2 MEC-CP842-1.0E

5.1.2 Waste Tape Duct (Every 8 Hours)

Point

Cut waste tape is carried through a duct as shown in the figure below. If the duct

becomes clogged, the clogged waste tape may interfere with tape being fed from the

feeder, resulting in tape feed problems and part pick-up errors.

If a tape feed problem occurs during automatic operation, inspect and clean the duct.

Procedure

Press the EMERGENCY STOP button, and then clean the duct with a vacuum

cleaner. Do not use an air blower.

WARNING

Press EMERGENCY STOP before performing this procedure.

C746M3002

Duct

Feeder