00198168-02_Technical_Training_TX-Series_EN.pdf - 第18页

2 Machine Basic Overview 2.3 Overview main components 18 Technical Training SIPLACE TX-Series 10/2016 2.3 Overview main components Placement Heads The following placement heads can be installed on TX machines: C&P20 …

100%1 / 266
2 Machine Basic Overview
2.2 Machine Overview
Technical Training SIPLACE TX-Series 10/2016 17
2.2 Machine Overview
General Overview
T - Transport direction
1. Location 1
2. Location 2
3. COT for location 2
Machine Switches
T - Transport direction
1. Status lamp
2. E-Stop
3. Start / Stop button
4. Switch to dock / undock COT
5. Main switch
Main Component Locations
T - Transport direction
1. Vacuum pump location
2. Gantry 1
3. Gantry 2
4. Switch Mode Power Supply Location 2
5. Pneumatic unit
6. SIPLACE LAN and transport interface
connections, power in
2 Machine Basic Overview
2.3 Overview main components
18 Technical Training SIPLACE TX-Series 10/2016
2.3 Overview main components
Placement Heads
The following placement heads can be installed on TX machines:
C&P20 P Twin Head* C&P20 M2** (red handle)
CPP CPP M** (red handle)
*Twin Heads or stationary cameras are not supported on TX micron
**C&P20 M2 and CPP M only supported by TX micron
PCB Transport System
The following conveyor configurations are
possible:
●
Standard: Dual Conveyor Fixed rail outer
●
Dual Conveyor Fixed rail left*
●
Dual Conveyor Fixed rail right*
●
Flexible Dual Conveyor Fixed rail left*
●
Flexible Dual Conveyor Fixed rail right*
*configurable
2 Machine Basic Overview
2.3 Overview main components
Technical Training SIPLACE TX-Series 10/2016 19
Changeover Tables
●
Each feeder location has a change over
table (COT).
●
Depending on the machine type and head
configuration the COTs have a possible
inner and outer machine position.
●
The feeder count depends on the head
configuration.
Feeder
The TX uses the SIPLACE X-Feeder sizes and
types:
●
4mm, 8mm, 12mm, 16mm, 24mm
●
32mm, 44mm, 56mm
●
GlueFeeder
●
LDU-X (Linear Dipping Unit)
Tray Carrier
●
JTF-ML
Shuttle
●
TX machines with serial number ≥ TA500
●
TX micron machines
The power to the shuttle is supplied by the
TX machine, the shuttle is controlled by
the TXmachine software.
Note:
For input, a combination of shuttle and option
LP barcode is possible.
For output, a combination shuttle and conveyor
extension is NOT possible.