00198168-02_Technical_Training_TX-Series_EN.pdf - 第263页
11 JTF-ML Room for Your Sketches and Notes Technical Training SIPLACE TX-Series 10/2016 263 Room for Your Sketches and Notes
11 JTF-ML
11.7 Maintenance
262 Technical Training SIPLACE TX-Series 10/2016
11.7 Maintenance
Maintenance item for Conveyor system (Details refer to maintenance Job card).
Maintenance content Interval Requirement
●
Check the feeder for damaged or broken parts. Weekly None
●
Check the conveyor belts for dirt, nicks, or other signs of dam-
age.
Weekly None
●
Clean the feeder. Monthly
●
Clean the conveyor belts and the tray platform.
●
Wipe down the belts and platform with isopropyl alcohol.
Monthly
●
Check the urethane pinch roller attached to the tray clamping
mechanism for signs of wear or damage.
●
Replace it if necessary.
Monthly
All bearings used in the machine are sealed and do not require lubrication. The feeder uses dry-run
chains and these should not be lubricated.
11.8 Excercise: JTF-ML
1. JTF-ML is an option for tray package component, which of the following is true.
A JTF-ML communicates with the BOXPC by CAN-Bus directly.
B Additional power supply retrofitting is necessary for JTF-ML.
C JTF-ML is similar to a feeder; there is no any ZPC of feeder axis and lift axis necessary.
D When refilling component on JTF-ML, the "stop" button must be pressed.
11 JTF-ML
Room for Your Sketches and Notes
Technical Training SIPLACE TX-Series 10/2016 263
Room for Your Sketches and Notes
11 JTF-ML
Room for Your Sketches and Notes
264 Technical Training SIPLACE TX-Series 10/2016