00198168-02_Technical_Training_TX-Series_EN.pdf - 第29页
3 Setting Up the Machine 3.1 Setting up the TX Machine Technical Training SIPLACE TX-Series 10/2016 29 3 Setting Up the Machine 3.1 Setting up the TX Machine Checking a delivery ● Store the machine in the packaging crate…
2 Machine Basic Overview
Room for Your Sketches and Notes
28 Technical Training SIPLACE TX-Series 10/2016
3 Setting Up the Machine
3.1 Setting up the TX Machine
Technical Training SIPLACE TX-Series 10/2016 29
3 Setting Up the Machine
3.1 Setting up the TX Machine
Checking a delivery
●
Store the machine in the packaging crate until room temperature has been reached. There is
otherwise a risk of condensation occurring.
●
Check the delivery for damage.
●
Check the shock sensors.
●
Unpack the machine and the accessories and check the delivery for completeness
(reference delivery note).
●
Document the result in the installation report / acceptance testing report.
NOTICE
Always use a pallet and a forklift truck to transport the machine over longer distances in
order to avoid damaging the machine.
Attachment points on the transport crate or pallet
Attach the forklift truck only at the points identified by (A).
1. Machine feet: The machine feet are fixed with 3 angle brackets on the pallet
2. Component table position on the pallet
WARNING
Make sure that the forks are evenly loaded when you lift the machine.
► A firm support between the forks and machine will prevent the machine tilting when it
is raised. This will also prevent a one-sided load on the machine feet, which would
deform the fixing of the machine feet.
► It is recommended that a second person watch the machine as it is raised to make
sure that the machine does not tip to one side when lifted by the forklift truck.
3 Setting Up the Machine
3.1 Setting up the TX Machine
30 Technical Training SIPLACE TX-Series 10/2016
1. The balance point of the machine is not the center of the machine.
●
Attention: Don`t use the Input Side of the machine to lift up.
●
Please use the Output Side with a minimum fork of 617mm or with a distance between the
forks of 937mm.
●
Don`t move the machine outside of the center from the machine.
●
Move with fork next to the feet only; there is no other way to move the machine in line.