00198168-02_Technical_Training_TX-Series_EN.pdf - 第232页

9 Control and Communication

9.12 Excercise: Control and Communication

Technical Training SIPLACE TX-Series 10/2016 231

9.12 Excercise: Control and Communication

1. Which of the following statements is true regarding TX communication system?

A CIN Box is instead of communication board (CAN bus card).

B Vision GigE system is instead of vision hotlink system.

C There are three different bus systems, CAN bus, Gantry CAN bus and FDB.

D All of the above.

2. Which parts do not communicate with the BOXPC via the CAN bus system in TX?

A CIN-Box.

B Conveyor controller (TSP).

C FCU (Feeder control unit), MHCU and MGCU.

D I/O unit (input/ output module).

3. Which of the following statements is true regarding parts exchange?

A No setting required after exchanging a MGCU.

B No setting required after exchanging a MHCU.

C No setting required after exchanging a FCU.

D No setting required after exchanging a CIN-Box.

4. CIN-Box is connected to BoxPC with CAT5 cable, and uses CAN bus cable to

communicate with subsystem.

True …………………………………………………………………………………………………

False …………………………………………………………………………………………………

5. List all of subsystems which are controlled by CAN bus.

………………………………………………………………………………………………………

6. List the parts which are controlled by FCU.

………………………………………………………………………………………………………