00193892-0402_AI_FeederCoverFlap_DE+EN.pdf - 第57页
Assembly instructions Feeder cover flap, SIPLACE HF-series / X-series / D3 05/2009 Edition 57 : Put a feeder on the outer lef t track and the outer right track and on the mid dle of the changeover t able. : Adjust the he…
Assembly instructions Feeder cover flap, SIPLACE HF-series / X-series / D3
05/2009 Edition
56
: Adjust the plates with the four screws so that the headless set screws hit the actuators right
in the middle. To adjust this position the switch at the machine frame can also be moved in Y-
direction.
2
2
: Install the nozzle changer if present
: Connect the machine to the power supply.
: Switch on the placement system.
2
Do not execute a reference run, because the feeder protective plate is not already right adjusted
and may cause a head crash. 2
2
: Put in the changover table.
: Shut down the station computer.
: Switch off the placement system.
2
2
Screws to adjust the plates
Headless set screws
Actuator
Assembly instructions Feeder cover flap, SIPLACE HF-series / X-series / D3
05/2009 Edition
57
: Put a feeder on the outer left track and the outer right track and on the middle of the
changeover table.
: Adjust the height of the feeder protective plate with the left and the right headless set screw,
so that the distance between the bottom of the plate and the highest point of the feeder is about
1mm. The plate must not hit the feeders. Fix the screws with the screw nuts. Secure the screws
afterwards with screw locking paint.
2
2
: Repeat the described work steps at all locations where Feeder cover flaps should be installed.
2
: Turn on the machine and check the correct function of the protective plates.
: Before you execute a reference run, push the gantry carefully across the plate to make sure,
that there is enough space between the nozzle and the plate.
: Calibrate the nozzle changer and the nozzle removal unit.
2
protective
plate
distance between plate and
feeder should be about 1 mm
highest point of the feeder
(here a 2x8mm S feeder)
Assembly instructions Feeder cover flap, SIPLACE HF-series / X-series / D3
05/2009 Edition
58
2.6 Assembly Feeder cover flap (old version)
2.6.1 Overview
These flaps are not available any more. This manual is only necessary for a spare parts assembly.
The feeder cover flap is assembled in the same way on
both sides of the machine, only the other
way around. The manual shows photographs of both sides. 2
2.6.2 Restriction
The “Feeder Protection SIPLACE HF” can not be used in conjunction with the 6-nozzle revolver
head and nozzle types 820, 821, 921. When these short nozzles are used the segment touches
the protection plate before the nozzle touches the part in the pocket. 2
2.6.3 Tools and consumables required
– Set of hexagon socket spanners
– Caliper gauge
– Power drill or cordless screwdriver
– Metal drill bit (5 mm)
– Counterbore (5 mm at the tip / 12 mm at the shaft)
– Rose bit
– Deburrer
Additionally for HF-series up to A-001: 2
– Drilling gauge (item no.: 03033639-01)
Additionally for HF-series from A-001 / X-series: 2
– Drilling gauge (item no.: 03011814-01)