3OM-1751-002w_G5S.pdf - 第205页
3OM-1751 2-37 1303-001 2.5.6 "Each Ang. BGA" T ab Sheet [1] [2] [3] [4] F3B36 [1] Nozzle 1 through 15 In this section, each nozzle No. is displayed. [2] Head 1 and Head 2 X (Horizontal) and Y (V ertical) [mm] W…
3OM-1751
2-361303-001
2.5.5 "Each Ang. Lead" Tab Sheet
[1] [2]
[3]
[4]
F3B35
[1] Nozzle 1 through 15
In this section, each nozzle No. is displayed.
[2] Head 1 and Head 2
X (Horizontal) and Y (Vertical) [mm]
When the applicable component is a leaded one, conversion and addition
are made in response to the placement angle while the target position for
placement is being computed.
[3] Head Direction Selection Buttons
When this button is selected, the head direction is adjusted for each selected
angle.
[4] [Head 1 Clear] Button, [Head 2 Clear] Button
Using these buttons, the data parameters for all the nozzles in the
corresponding head are performed.
2.5 "Head" Window
Graphic
Development
3OM-1751
2-371303-001
2.5.6 "Each Ang. BGA" Tab Sheet
[1] [2]
[3]
[4]
F3B36
[1] Nozzle 1 through 15
In this section, each nozzle No. is displayed.
[2] Head 1 and Head 2
X (Horizontal) and Y (Vertical) [mm]
When the applicable component is a BGA/CSP one, conversion and addition
are made in response to the placement angle while the target position for
placement is being computed.
[3] Head Direction Selection Buttons
When this button is selected, the head direction is adjusted for each selected
angle.
[4] [Head 1 Clear] Button, [Head 2 Clear] Button
Using these buttons, the data parameters for all the nozzles in the
corresponding head are performed.
2.5 "Head" Window
Graphic
Development
3OM-1751
2-381303-001
2.5.7 "Head Offset" Window
[1]
[3]
[2]
[4]
[5]
[6]
[7]
F3B37
[1] Head up/dn
The set parameters are used to adjust the deviations (caused when the master
nozzle is attached to the head and lowered by the specied distance with the
combined operations of the head and nozzle U/D axes) based on the design
value of the distance between the upper surface of PCB and the lower surface
of the nozzle. The amount of movement of each axis is separately reviewed.
When the measured value is greater than the design one, a plus sign must be
afxed to the offset data.
[2] Chute level (Shipment)
These offset parameters for backup are used to calculate the difference of
the chute level value in shipping from that in the head change, by means
of measuring the chute level in advance when the machine is shipped and
performing the chute level height teaching when the head is changed.
2.5 "Head" Window
Graphic
Development