3OM-1751-002w_G5S.pdf - 第223页
3OM-1751 2-55 1303-001 2.6.7 "Press-Fit Work" T ab Sheet [1] [2] F3B54 [1] Nozzle In this section, each nozzle No. is displayed. [2] Head 1 and Head 2 Press Fit Level [mm] The correction is performed when the n…
3OM-1751
2-541303-001
2.6.6 "Nozzle Axis" Tab Sheet
[1] [2]
F3B53
[1] Nozzle
In this section, each nozzle No. is displayed.
[2] Head 1 and Head 2
X (Horizontal) and Y (Vertical) [mm], Z [Ang]
Displayed is the offset data for nozzle replacement.
The displayed values indicate the offsets for the lowest levels of the special
nozzles on the heads.
The lowest level of each nozzle is measured by the component recognition
camera and the difference between the actual and recognized levels is
compensated for.
2.6 "Nozzle" Window
Graphic
Development
3OM-1751
2-551303-001
2.6.7 "Press-Fit Work" Tab Sheet
[1]
[2]
F3B54
[1] Nozzle
In this section, each nozzle No. is displayed.
[2] Head 1 and Head 2
Press Fit Level [mm]
The correction is performed when the nozzle attachment position is deviated
due to the component change in these text boxes.
Positive value reduces the operation range and negative value increases the
operation range.
2.6 "Nozzle" Window
Graphic
Development
3OM-1751
2-561303-001
2.6.8 "Noz Sel Axis Pos" Tab Sheet
[2][1]
F3B55
[1] Nozzle
Each Nozzle No. is displayed in these boxes.
[2] Head1, Head2
Z [Ang]
These offset parameters are used to correct the position relation between the
nozzle selection axis and the nozzle.
2.6 "Nozzle" Window
Graphic
Development