00198442-01_UM_TX-V2_EN.pdf - 第266页
6 Station extensions Use r manual SIPLACE TX V2 6.1 Nozzle changer From software version 711.1 04/2018 270 6 Fig. 6.1 - 9 Nozzle changer for C&P/CPP - changing the mag azine (1) Lever for ra ising the magazine (2) Pa…
User manual SIPLACE TX V2 6 Station extensions
From software version 711.1 04/2018 6.1 Nozzle changer
269
6
WARNING
Risk of head crashes with protruding lever
Any lever that is protruding over the magazine (item 1 in fig 6.1 - 9
) can result in a head
crash.
You should therefore make sure that the lever does not protrude over the maga-
zines.
6 Station extensions User manual SIPLACE TX V2
6.1 Nozzle changer From software version 711.1 04/2018
270
6
Fig. 6.1 - 9 Nozzle changer for C&P/CPP - changing the magazine
(1) Lever for raising the magazine
(2) Parallel pin, engages in the hole in the magazine
(3) spring pin for triggering the microswitch
(4) Pin of the slide mechanism, moves the locking plate
(5) Ball of snap fastener
(6) Parallel pin, engages in the slot in the magazine
(7) Locking plate in the "magazine locked" position
6
Place the magazine on the snap fastener balls (item 5 in fig. 6.1 - 9, page 270).
Press the magazine down evenly so that the snap fastener balls engage in all the snap fas-
teners at the same time.
PLEASE NOTE
Move the locking plate into the "Magazine locked" position.
Before inserting, align the magazine so that the centering pins (items 2 and 6 in fig.
6.1 - 9
, page 270) slide into the centering holes and slot.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
User manual SIPLACE TX V2 6 Station extensions
From software version 711.1 04/2018 6.1 Nozzle changer
271
6.1.3.3 Position detection
Each magazine for the nozzle changer has two fiducials, to determine the position.
6
Fig. 6.1 - 10 Nozzle magazine - holder numbering, fiducials for determining the position and angular position
(1) Locking plate in the "magazine open" position
(2) Fiducials for determining the position
(1)
(2)
(2)