00197385-03_SR70x_FeatureDescription_DE_EN.pdf - 第94页

SIPLACE Statio n Softw are 70x / Feature D esc ription Ausgabe 05/2014 Edit ion 94 Items 3 to 5: LED for A ir Blast Valve, DI P Sw itch and Reject B in These s tates are d ispla yed in t he new FCU Inputs/Outputs view un…

SIPLACE Station Software 70x / Feature Description Ausgabe 05/2014 Edition

Item 1: Nozzle Changer State

This state is displayed in the Nozzle changer view on the GUI. The state can be modified (Open /

Close).

Figure 7-31: Lock state of nozzle changer

Item 2: Magazine State

This state is displayed in the Safety circuit view on the GUI.

Figure 7-32: Magazine state

SIPLACE Station Software 70x / Feature Description Ausgabe 05/2014 Edition

Items 3 to 5: LED for Air Blast Valve, DIP Switch and Reject Bin

These states are displayed in the new FCU Inputs/Outputs view under Manual operations –

Subsystems on the GUI and are accessible as of the Machine Service activity level.

Figure 7-33: States of air blast valve, DIP switch and reject bin

There are no sensors to check the state of the air blast valves. Only the ports to which the air blast

valves are connected can be tested - no matter what is actually connected and operable there.

With the Air blast valve button it is possible to enable the display of changes on these ports. The

displayed state can be modified on the GUI.

The test mode to check the presence / absence of a reject bin can be enabled and disabled with

the DIP switch, bit 3: Reject bin test mode button.

Only bit 3 (=reject bin test mode) can be enabled and disabled for the DIP switch.

7.33 DX4 Placement Machine - PCB Barcode Reader Functions

Compatible mode: Complete, if the barcode reader is upgraded

All PCB barcode reader functions that can be used on the SX4 placement machine can be

unrestrictedly used on the DX4 placement machine as of this station software version.

SIPLACE Station Software 70x / Feature Description Ausgabe 05/2014 Edition

7.34 Automatic Deactivation of the Component Sensor

Compatible mode: Complete

To avoid scattered light, the component sensor of the CPP placement head is automatically

deactivated before the component centering with the stationary camera or the coplanarity

measurement are performed.

7.35 Automatic Deactivation of the Compressed Air

If the compressed air was automatically deactivated for the CPP and C&P20 placement heads in

the 705 station software, this setting had to be manually deactivated under Settings – Machine

settings, before the embedded software was downloaded to the subsystems.

As of the 706 station software this setting is automatically deactivated.

7.36 Automatic Pin Positioning with Smart Pin Support

Compatible mode: Not supported

Smart Pin Support is also supported on the new X3S, X4S and X4Si placement machines. When

Smart Pin Support is used, each gantry has to be equipped with a pin picker.

The Auto Configuration has been adjusted to configure the installation location and position of the

pin pickers and the pin magazines correspondingly.

As of this station software version, the support pin positions can be periodically checked. The

setting to enable the check and time interval can be made under Settings – Machine options. If

necessary, the pin positions will be reset automatically.