444CEOM1-CM202.pdf - 第114页
Page 3-16 444C-E-OMA03-A01-03 Production Information 3-3-4 Reset This is used to reset production information. Choose the information you would like to reset. It is possible to choose more than a piece of information at …
Page 3-15
FUNCTIONS
3
444C-E-OMA03-A01-05
Production Information
3-3-3 Pick-up Information
The chip pick-up information during production is displayed for each feeder or each nozzle.
• When there are any vacancies of feeder address in changing production board types, they are
not displayed.
• Without reset, data will be added on irrespective of switchover of board types.
•“Count” on Pick up information screen = “Pick up miss” + “Recog miss”
• Whenever Sel head or All head is pressed, each in-depth information is displayed.
For each feeder
The pick-up information of the selected stage is displayed for each feeder.
Error scrn
Displays the latest error image.
Sel head
All head
Toggles each detailed information.
Every time you press , the screens are changed over.
For each nozzle
The pick-up information of the selected stage is displayed for each nozzle.
Feedeer
Nozzle
Page 3-16
444C-E-OMA03-A01-03
Production Information
3-3-4 Reset
This is used to reset production information.
Choose the information you would like to reset.
It is possible to choose more than a piece of
information at a time. When you press the
switch again, it is canceled.
Press Run .
Press Yes when the message appears.
1
2
Page 3-17
FUNCTIONS
3
3-4 Machine Adjustment
This is used when you check the motion and make an adjustment of each part of the machine.
∗ On the main menu (default state) in the operator mode, you cannot select this function.
1. Press
Machine
adjust
on the main menu.
•“Machine adjustment menu” is displayed.
∗ Pressing a switch displays each setting screen.
NOTICE
When returning to the main menu by pressing , a message may be displayed.
· When deciding whether to put back the tape feeding rod if it has come out
· When retracting the Z-axis to the origin position, if it has been lowered, so as to
prevent nozzle interference
3-4-1 Returning to Origin
This is used to return all the axes to their origins.
∗ Make sure no board is on the conveyor beforehand.
∗ After you have pressed Return to origin on the machine adjustment menu, make sure the servo
switches are ON, and then press
UNLOCK
→
START
. All the axes return to their origins.
444C-E-OMA03-A01-03
Appears only if the optional nozzle changer is
installed.
( 3-4-4 Nozzle Changing (Option))
Nozzle exch