00194474-0702_AI_HeadReconfig_X_605_DE+EN.pdf - 第166页
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits 07/2010 Edition 166 2.9.2 Removing the T winHead 2 Wear an ESD ar mband for the whole time you are working on the placement h…
Head Reconfiguration Kits 2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits
07/2010 Edition
165
: Detach the IC camera cable from the connections on the base plate.
: Push the connecting cable into the machine frame. They are safely stored there.
2
: Replace the two upper screws DIN912 M6 x 35 - 8.8(item no.: 00845062-) with the set screws
DIN913 M6x50 - ST and use them to fix the partition plate for fiducial (item no.: 03022077-)
2
The fiducial plate is very heavy. 2
2
: Loosen the lower two screws (DIN 913 M6x50 - ST, item no.: 03005958-) on the base plate of
the IC camera and remove the camera.
: Loosen the four screws (M6) on the IC camera base plate and remove.
2
Removing the FC camera (if present) 2
: To remove the flip-chip camera, read the
Assembly instructions for the FC camera, digital 16x16 (SST 25) (item no.:00194554-).
2
The fiducial plate for the FC camera is removed in a different way than the IC camera!
It can fall off if it is dismantled in the same way,. 2
If it is not a two-gantry placement area and there is no TwinHead attached to the other gantry, you
can remove the vision controller in the sub- / main distributor. 2
4 screws
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits
07/2010 Edition
166
2.9.2 Removing the TwinHead
2
Wear an ESD armband for the whole time you are working on the placement head and servos. 2
2
: Remove the blanking shield (2 screws).
2
: Detach the exhaust air hoses shown in the photograph below.
2
2 screws
Head Reconfiguration Kits 2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits
07/2010 Edition
167
: Detach these hoses and the blanking plug.
2
2
Blanking plug
Hoses
Pneumatic hoses
for machines up to
serial no. B-078