00194474-0702_AI_HeadReconfig_X_605_DE+EN.pdf - 第172页
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits 07/2010 Edition 172 : Dismantle the n ozzle station and the ca ble clip (see photog raph). 2 : Close off th e open exit from …
Head Reconfiguration Kits 2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits
07/2010 Edition
171
2.10.1 Removing the nozzle changer
: To remove the nozzle changer, please read the assembly instructions for the X series nozzle
changer (item no.:00194482-).
2
Risk of a head crash: Always run the placement heads with the appropriate nozzle changer. The
wrong nozzle changer causes a risk of a head crash. 2
2
2
On the subject of the reject bin sensor, also read the assembly instructions for the reject bin sen-
sor, SIPLACE HF series / X series (item no.:00194550-). 2
2.10.2 Removing the nozzle station (description for component trolley docking unit
03015680-06 with 1-wire hub)
: Disconnect the air supply at the T-piece (see photograph).
: Remove the T-piece for the nozzle station from the component trolley docking unit (see photo-
graph).
: Remove the fine flow restrictor.
2
Disconnect hose from
the T-piece
Remove T-piece for
nozzle station
Remove fine flow
restrictor
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits
07/2010 Edition
172
: Dismantle the nozzle station and the cable clip (see photograph).
2
: Close off the open exit from the T-piece with a plug.
2
Dismantle the nozzle station
and cable clip
T-piece on component trolley docking unit
Head Reconfiguration Kits 2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits
07/2010 Edition
173
2.10.3 Removing the nozzle station (description for the new component trolley
docking unit 03015680-07 with CAN node for tape cutter control board)
2
The component trolley docking unit must be released according to the installation location (single
portal placement area) and pushed outwards.
It is essential to read the respectively valid service manual in this connection.
Fasten the component trolley docking unit in place after completing the work and measure all at-
tachment parts (nozzle changer). 2
2
: Remove the cover plate from the component trolley docking unit.
2
2
2
2
2
2
2