00194474-0702_AI_HeadReconfig_X_605_DE+EN.pdf - 第183页

Head Reconfiguration Kits 2 Assemb ly Instructions - SIPLACE X-Series Head Reconfiguration Kits 07/2010 Edition 183 : Plug the DLM2 head adapter bo ard (item no. 03019066-) from below into the head inter face board, and …

100%1 / 276
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits
07/2010 Edition
182
2.11.2 Installing the placement head
: Place the DLM head template on the head fixing plate.
Remove any excess screws and add any necessary screws:
fixing screws: 4x DIN912 M4x18 - 8.8 (item no. 00095023-),
Sealing screws: 9x DIN913 M4x6 - ST (item no. 00309422-), secure with gray thread lock paint
(item no. 00318199-)!
Screws in the wrong place could affect the flow of cooling air to the X-axis motor.
2
2
2
Always use the standard tool.
Make sure that the screws are of the right length. The lengths are different for C&P heads and the
TwinHead.
If you use the wrong screws, there is a risk of damaging the thread in the head plate. 2
.
Seal for
the head plate
Fixing
C&P 6/12
Head Reconfiguration Kits 2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits
07/2010 Edition
183
: Plug the DLM2 head adapter board (item no. 03019066-) from below into the head interface
board, and screw in place.
: Screw the bolts and nuts onto the adapter board before you fit it.
2
: Fit the SM board, modular (item no. 00344488-) on the DLM2 head adapter (using distance
bolts) and fix it with the corresponding screws.
Bolts
Spacer bolt, type B i/a-M3x7-ST Item no. 00324407-
Nut
DIN985 M3 - A2-70 Item no. 00328897-
Screws
DIN912 M3x6 - A2 Item no. 00201463-
Bolt with nut
Attach bolt here
Strain relief
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits
07/2010 Edition
184
: Fit the strain relief using the three screws on the left (see photograph above).
2
2
2
The two right-hand screws must be removed - they are not needed. 2
2
: Set the star resolution switch to 25.
The switch can be found underneath the placement head.
2
: Fit the placement head and fix in place with four screws.
Make sure that you use screws of the right length and observe the correct torque:
DIN912 M4x18 - 8.8 (item no. 00095023-), tightening torque: 2.7 Nm.
With screws two and three, you should first remove one sleeve to make the screws more ac-
cessible.