182050 User manual.pdf - 第20页
semi automatic 0$&+,1( 352*5$ 00,1* 67$*($ ),7 648((* ((6 1.10 User Manual Software Ve rsion 07SP02 Squeegee Reference Hei ght Every time new squeegees are moun ted onto the machine, the squeegee height must b…
semi automatic
0$&+,1(352*5$00,1*
67$*($),7648((*((6
Software Version 07SP02 User Manual 1.9
6. Fit the rear squeegee onto the rear squeegee mount, tightening the thumb-
screws until they are finger tight.
7. Fit the front squeegee onto the front squeegee mount, ensuring that the
thumbscrews are only finger tight.
8. Lower the printhead cover.
9. Press the System button.
10. Select Continue (F1).
Continue
semi automatic
0$&+,1(352*5$00,1*
67$*($),7648((*((6
1.10 User Manual Software Version 07SP02
Squeegee
Reference Height
Every time new squeegees are mounted onto the machine, the squeegee
height must be calibrated to a new reference height setting. Carry out the steps
below to set the squeegee reference height. When set, the reference height is
stored in the machine software as the zero pressure position.
1. Press Calibrat Heights (F2).
The message ‘Remove Screen Before Commencing Pressure Calibra-
tion’ is displayed.
2. Press Exit (F8).
3. Press Change Screen (F5).
The message ‘Open Cover and Remove Screen’ is displayed.
4. Raise the printhead cover.
5. Toggle screen clamp switch to up position (Off) (standard chase only).
Change
Squeegee
Calibrat
Heights
Exit
Continue
Restore
Defaults
Exit
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
semi automatic
0$&+,1(352*5$00,1*
67$*($),7648((*((6
Software Version 07SP02 User Manual 1.11
6. Remove the stencil from the machine.
7. Lower the printhead cover.
8. Press the System button.
9. Press Calibrat Heights (F2).
The message ‘Ensure that the Correct Squeegees are fitted’ is dis-
played.
10. Press Continue (F1).
The message ‘Set Squeegee Pressure Height’ is displayed.
Either:
11. Press Adjust (F2).
The following window is displayed:
12. Using Next, Previous, Incr. and Decr. (F4, F5, F6 and F7) enter the
squeegee heights parameters as necessary.
Change
Squeegee
Calibrat
Heights
Exit
Continue
Restore
Defaults
Exit
Adjust Save
Front
Squeegee
Rear
Squeegee
Step
Up
Step
Down
Exit
Squeegee Heights Parameters
Front Zero Ref
Rear Zero Ref
4000
4040
Next Previous Incr. Decr. Exit