182050 User manual.pdf - 第233页
semi automatic &21680$ %/(5( 3/(1,6+0 (176 %/8(81' (56&5 ((1& /($1(5 Software Version 07SP02 User Manual 8.25 20. T oggle the screen clamp to th e down position ( ON ) (standar d chase only). 21. Lowe…
semi automatic
&21680$%/(5(3/(1,6+0(176
%/8(81'(56&5((1&/($1(5
8.24 User Manual Software Version 07SP02
16. Ensure the cleaner paper has been routed correctly, from underneath the
paper roll (1) rearwards across the squeegee assembly and threaded
between paper rod and shaft (2).
17. Press Prime Paper (F5).
The message ‘Press the two control buttons to feed paper’ is displayed.
18. Using the two button control, prime the paper ensuring it feeds correctly.
19. Insert the stencil into the printer, ensure correct orientation and print justifi-
cation.
1
2
Screen
Clamps
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
semi automatic
&21680$%/(5(3/(1,6+0(176
%/8(81'(56&5((1&/($1(5
Software Version 07SP02 User Manual 8.25
20. Toggle the screen clamp to the down position (ON) (standard chase only).
21. Lower the printhead cover.
22. Press the System button.
23. Press Change Screen (F2).
24. Press Exit (F8).
Change
Screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
Change
screen
Board
Clamps
Prime
Paper
Prime
Solvent
Exit
semi automatic
&21680$%/(5(3/(1,6+0(176
9257(;3/8681'(56&5((1&/($1(5
8.26 User Manual Software Version 07SP02
VORTEX PLUS UNDERSCREEN CLEANER
Provision is made on the printer for automatic underscreen cleaning. This is
carried out using a cleaning cassette which contains a wet and a dry cell. The
wet cell is impregnated with an appropriate solvent. A cleaning cycle consists
of a single return stroke incorporating a wet and dry wipe with or without
vacuum.
The cleaning options can be programmed into a particular product file so that
they take place at preprogrammed intervals or they can be selected, directly
from the MMI, to take place at the operators discretion.
Programming
Operation
The screen clean parameters can be setup when editing a product file, while
setting up a new product. It may be more convenient to set these after the
product has been setup and printed and screen cleaning requirements have
been decided upon.
The parameters to be edited that affect the operation of the underscreen cleaner
are listed below with a definition of each as an aid to setup:
Front Start Offset The distance, in from the front edge of the board, at which the cleaner is to finish.
Minimum Maximum Increment Default
-60mm 60mm 1mm 30mm