182050 User manual.pdf - 第254页
semi automatic &21680$ %/(5(3/ (1,6+0 (176 352)/2: 8.46 User Manual Software Ve rsion 07SP02 32. Press Prime ProFlow (F6). If it is possibl e to carry out the pr ime ProFlow function t he message ‘ Performing knead …
semi automatic
&21680$%/(5(3/(1,6+0(176
352)/2:
Software Version 07SP02 User Manual 8.45
25. Remove the snap fit lid from a new cassette. Fit a new cassette (1) into the
carrier recess (2) and secure into place with the retaining pins (3).
26. Remove the sealing foil from the top of the new cassette.
27. Hinge the clamp brackets (1) inwards to position the cassette onto the
transfer head, secure in place by tightening the thumbscrews (2).
28. Lower the pressure mechanism (3) in place until the latch engages.
29. Lower the printhead cover.
30. Press the System button.
31. Select Setup ProFlow (F4).
3
2
1
3
2
2
3
1
1
Mode
Load
Data
Edit
Data
Setup
ProFlow
Change
Screen
Change
Tooling
Change
Language
Exit
semi automatic
&21680$%/(5(3/(1,6+0(176
352)/2:
8.46 User Manual Software Version 07SP02
32. Press Prime ProFlow (F6). If it is possible to carry out the prime ProFlow
function the message ‘Performing knead off-image.’ is displayed. If it is
not possible the function is deferred until it is, ie at the start of a print stroke
with a board loaded.
NOTE
If stencil protection is set to On in the current board file, Prime ProFlow is
not possible, priming can be carried out by kneading over-image.
33. Press Exit (F8).
34. Press Exit (F8).
Change
ProFlow
Load
Cassette
Prime
ProFlow
Exit
Change
ProFlow
Load
Cassette
Prime
ProFlow
Exit
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
semi automatic
&21680$%/(5(3/(1,6+0(176
352)/2:
Software Version 07SP02 User Manual 8.47
Retention System Replacement
Due to wear over prolonged periods, it is necessary to replace the wiper foils
and skis. An obvious indication of blade deterioration is print medium left
deposited on the screen after a print cycle, an example of this indication is
shown in the figure below.
Figure 8-1 Example of ProFlow Wiper Wear
Replace the wipers and skis as follows:
WARNING
SOLDER PASTE AND SOLVENTS. WHEN USING OR HANDLING ANY SOLDER
PASTE OR SOLVENT FORMULATION THE MANUFACTURERS’ RECOMMEND
SAFETY PRECAUTIONS MUST BE STRICTLY ADHERED TO.
WARNING
PROTECTIVE CLOTHING. APPROVED PROTECTIVE CLOTHING SHOULD BE
WORN BY SOLDER PASTE AND SOLVENT HANDLERS AT ALL TIMES TO
ELIMINATE FUME INHALATION, EYE CONTACT, SKIN CONTACT AND
INGESTION.
1. Press Setup (F6).
2. Press Setup ProFlow (F4).
3. Press Change ProFlow (F1). The message ‘Replace ProFlow Cover
then Close Cover and Press Continue’ is displayed.
4. Raise the printhead cover.
Run
Open
Cover
Paste
Load
Clean
Screen
Setup Monitor Maint.
Mode
Load
Data
Edit
Data
Setup
ProFlow
Change
Screen
Change
Tooling
Change
Language
Exit
Change
ProFlow
Load
Cassette
Prime
ProFlow
Exit