182050 User manual.pdf - 第58页
semi automatic 0$&+,1( 352*5$ 00,1* 67$*(( )250 )/(;722 /,1* 1.48 User Manual Software Ve rsion 07SP02 b. Slide the left han d chase rail to the desir ed position i ndicated on the graduated sc ale. c. Release…
semi automatic
0$&+,1(352*5$00,1*
67$*(()250)/(;722/,1*
Software Version 07SP02 User Manual 1.47
23. Slide the appropriate size and number of FormFlex blanking plates on to the
tooling modules outside the area of the squeegees/ProFlow transfer head.
Secure the plates using the thumbscrews.
24. If ASM is fitted continue with Step 25. If the standard chase is fitted go to
Step 27b.
25. To adjust the width of the chase rails to accommodate the stencil for the
product file loaded, carry out the following:
a. Press and hold the left hand chase rail push button valve.
semi automatic
0$&+,1(352*5$00,1*
67$*(()250)/(;722/,1*
1.48 User Manual Software Version 07SP02
b. Slide the left hand chase rail to the desired position indicated on the
graduated scale.
c. Release the push button valve.
d. Repeat the procedure for the right hand chase rail.
26. If the stencil size is less than 29″ x 29″ the screen depth adjuster position is
to be adjusted as follows:
a. Slide the screen depth adjuster towards the front of the machine.
b. Lift the adjuster clear of the two locating screws.
semi automatic
0$&+,1(352*5$00,1*
67$*(()250)/(;722/,1*
Software Version 07SP02 User Manual 1.49
c. Using the inner pair of keyway slots locate the adjuster on the chase and
slide the adjuster to the rear of the machine to lock in place.
27. To adjust the screen depth adjuster for the product carry out one of the
following:
a. ASM, centre or front justified stencil - Set the screen depth adjuster to
Distance to Image. (Distance to Image = the measurement from the rear
face of the stencil frame to the front edge of the board image.)
b. Standard chase, centre justified stencil - Set the screen depth adjuster to
Board Width. (Board Width = the measurement from the rear face of the
stencil frame to the front edge of the board image.)
Standard chase, front justified - Set the screen depth adjuster to 508mm
(20″).
28. Ensuring for the correct orientation of the stencil, load the stencil against the
left hand chase rail and insert until the stencil is fully against the screen
depth adjuster.
29. Toggle screen clamp switch to down position (On) (standard chase only).
30. Lower the printhead cover.
31. Press the System button.