182050 User manual.pdf - 第23页

semi automatic 0$&+,1 (352*5 $00,1 * 67$*(% 352)/2: 6(7 83 Software Version 07SP02 User Manual 1.13 ST AGE 4B - PROFLOW SETUP If squeegees were use d when running the last produc t, carry out the Squeegees to …

100%1 / 266
semi automatic
0$&+,1(352*5$00,1*
67$*($),7648((*((6
1.12 User Manual Software Version 07SP02
13. Press Exit (F8).
14. Press Save (F3).
Or:
15. Using Step Up and Step Down (F6 and F7) as necessary to raise or lower
the front squeegee until it just touches the front rail.
16. Press Rear Squeegee (F5).
17. Using Step Up and Step Down (F6 and F7) as necessary to raise or lower
the rear squeegee until it just touches the front rail.
18. Press Save (F3).
19. Press Exit (F8).
20. Press Exit (F8).
21. Press Exit (F8).
Next Previous Incr. Decr. Exit
Adjust Save
Front
Squeegee
Rear
Squeegee
Step
Up
Step
Down
Exit
Adjust Save
Front
Squeegee
Rear
Squeegee
Step
Up
Step
Down
Exit
Adjust Save
Front
Squeegee
Rear
Squeegee
Step
Up
Step
Down
Exit
Adjust Save
Front
Squeegee
Rear
Squeegee
Step
Up
Step
Down
Exit
Adjust Save
Front
Squeegee
Rear
Squeegee
Step
Up
Step
Down
Exit
Adjust Save
Front
Squeegee
Rear
Squeegee
Step
Up
Step
Down
Exit
Change
Squeegee
Calibrat
Heights
Exit
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit
semi automatic
0$&+,1(352*5$00,1*
67$*(%352)/2:6(783
Software Version 07SP02 User Manual 1.13
STAGE 4B - PROFLOW SETUP
If squeegees were used when running the last product, carry out the Squeegees
to ProFlow Replacement Procedure, see Technical Reference manual, ProFlow
Module chapter - Replacement Procedures.
For setting the contact position, carry out the ProFlow Contact Position Setup,
see Technical Reference manual, ProFlow Module chapter - Adjustments and
Settings.
semi automatic
0$&+,1(352*5$00,1*
67$*(6&5((181/2$'
1.14 User Manual Software Version 07SP02
STAGE 5 - SCREEN UNLOAD
1. If there is no screen loaded go to Stage 6.
2. Select Change Screen (F5). The message ‘Open Front Cover and
Remove Screen’ is displayed.
3. Raise printhead cover.
4. Toggle screen clamp switch to up position (Off) (standard chase only).
5. Remove the stencil from the printer.
6. Lower printhead cover.
7. Press the System button.
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit