00197463-03_SM_CPP_Customer_EN.pdf - 第27页

3 Usability package 3.2 Retrofitting the usability package Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 27 Assembly of: ● Insertion aid top right / CPP [03118785‑xx] ● Label for insertion aid [03122619‑xx] ● RH…

100%1 / 120
3 Usability package
3.2 Retrofitting the usability package
26 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018
NOTICE
Small screws and screws with plastic threads
When tightening smaller screws and screws with plastic threads, observe the following pro-
cedure:
► Turn the screw first to the left, until it falls into the thread. Then tighten the screw care-
fully.
3.2 Retrofitting the usability package
Assembly of:
●
Cover for front plate / CPP [03077012‑xx]
Fig.19: Pulling off the protective sheet
► Pull the protective sheet off both sides of the
cover.
Fig.20: Fitting the cover
► Fit the cover on the front plate.
Assembly of:
●
Handle protector CPP assy. [031119772‑xx]
Fig.21: Fitting the handle protector
► Fit the handle protector assy for the CPP onto the
front plate.
 CAUTION!
Secure the screw with Loctite 243.
.
3 Usability package
3.2 Retrofitting the usability package
Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 27
Assembly of:
●
Insertion aid top right / CPP [03118785‑xx]
●
Label for insertion aid [03122619‑xx]
●
RH cylinder holder / CPP [03120201‑xx]
Fig.22: Replacing the cylinder holder
► Replace the RH cylinder holder. This is neces-
sary before you can fit the insertion aid.
Fig.23: Fitting the insertion aid
► Fit the "insertion aid top right / CPP".
Fig.24: Fitting the label
► Attach the "insertion aid label".
3 Usability package
3.2 Retrofitting the usability package
28 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018
Assembly of:
●
Ground connection (ground slit) of screwed joint CPP [03120256‑xx]
Fig.25: Fastening the ground connection to the screwed joint
► Screw the new ground connection to the screwed
joint using the straight cable lug.
 NOTICE!
Observe the correct installation direction.
.
Fig.26: Fastening the ground connection to the front section of
the head
► Fit the ground connection to the front section of
the head using the curved cable lug (if present).
 NOTICE!
Make sure that the curved cable lug does not
protrude beyond the handle protector for the
CPP.
.
Assembly of:
●
Label assembly marking CPP [03118678‑xx]
Fig.27: Fitting the label
► Attach the label to the position shown.