00197463-03_SM_CPP_Customer_EN.pdf - 第50页
5 Front plate, star, Z axis and smoothed distributor disc 5.4 Removing the valve terminal (only for heads from FS05 upwards) 50 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 Fig.69: Flexprint cable 1. Connector…
5 Front plate, star, Z axis and smoothed distributor disc
5.4 Removing the valve terminal (only for heads from FS05 upwards)
Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 49
5.4 Removing the valve terminal (only for heads from FS05
upwards)
Parts, equipment and tools
●
Replacing the valve terminal [03115167‑xx] (replaces: [03082217‑xx])
Overview
Fig.67: Star structure
1. Energy transmission for rotor
2. Valve terminal
3. Star carrier with DP drives
4. Single Core Solution (SCS).
5. Holding circuit with screwed joint
Fig.68: Valve terminal (front and back)
Valve terminal [03115167‑xx]
Preparation
► Remove the head from the machine. For details about removing and fitting the placement
head, refer to the service manual for your machine.
fit the head on the head mount [03056231‑xx].
► Make sure that the component sensor protective cap is fitted.
1.1.3 "Protecting the component sensor" [}8]
Removal (for heads from version 05)
► If required, dismantle the front plate.
5.1 "Replacing the front plate [03061102-xx]" [}35]
► Remove the star.
5.2 "Removing and fitting the star (only for heads from FS05 upwards)" [}43]
► Remove the energy transmission for the rotor.
5.6 "Replacing the energy transmission for the rotor [03068843‑xx]" [}63]
5 Front plate, star, Z axis and smoothed distributor disc
5.4 Removing the valve terminal (only for heads from FS05 upwards)
50 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018
Fig.69: Flexprint cable
1. Connector closed
2. Connector open
3. Flexprint removed
► Open the connector and remove the Flexprint
cable.
Fig.70: Screws fastening the valve terminal
► Remove the screws fastening the valve terminal:
1. The old valve terminal [03082217‑xx] is fixed with
six screws to the heads up to and including
FS04.
2. The new valve terminal [03115167‑xx] is fixed
with five screws to the heads up to number [KL-
J5-0162] .
3. The new valve terminal [03115167‑xx] is fixed
with six screws to heads from number [KL-
J5-0162].
Fig.71: Removing the valve terminal
► Lift the valve terminal off the star carrier.
5 Front plate, star, Z axis and smoothed distributor disc
5.4 Removing the valve terminal (only for heads from FS05 upwards)
Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 51
Installation
Fig.72: Checking the seal
► Check the position of the seal.
Fig.73: Checking the ball bearings
► Check the ball bearings.
These ball bearings may not protrude above the
surface.
NOTICE!
If the ball bearings are defective, you will
need to replace the valve terminal.
.
Fig.74: Inserting the valve terminal
► Place the valve terminal on the star carrier.
Pay attention to the correct position of the pins
and to the position of the Flexprint cable.