00197463-03_SM_CPP_Customer_EN.pdf - 第43页
5 Front plate, star, Z axis and smoothed distributor disc 5.2 Removing and fitting the star (only for heads from FS05 upwards) Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 43 5.2 Removing and fitting the star (…
5 Front plate, star, Z axis and smoothed distributor disc
5.1 Replacing the front plate [03061102-xx]
42 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018
Fig.52: Connecting the air hoses
► Attach the air hoses(1) to(4) for the return unit,
the screwed joint and the pressure control valve.
Pay attention to the correct installation position of
all air hoses.
Fig.53: Connecting the hose to the PRV
► Fit the air hose (1) to the pressure control valve.
CAUTION
Other installation instructions
► After performing installation, start the station software and check the zero point correc-
tion value for the Z axis.
► In the event of problems or if the data is not automatically applied, import the zero
point correction data from the head EEPROM into the machine data.
5 Front plate, star, Z axis and smoothed distributor disc
5.2 Removing and fitting the star (only for heads from FS05 upwards)
Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018 43
5.2 Removing and fitting the star (only for heads from FS05
upwards)
Overview
Fig.54: CPP head structure
1. Back plate
2. Smoothed distributor disc
3. Star
4. Front plate
Preparation
► Remove the head from the machine. For details about removing and fitting the placement
head, refer to the service manual for your machine.
fit the head on the head mount [03056231‑xx].
► Make sure that the component sensor protective cap is fitted.
1.1.3 "Protecting the component sensor" [}8]
Removal
Fig.55: Handle
► Remove the four screws(1) fastening the
handle(2) and remove the handle.
5 Front plate, star, Z axis and smoothed distributor disc
5.2 Removing and fitting the star (only for heads from FS05 upwards)
44 Service Manual SIPLACE Multistar (CPP / CPP M) 02/2018
Fig.56: Handle
► Remove the two screws (1) fastening the camera
cover (2) and remove the camera cover.
► If required, dismantle the front plate.
5.1 "Replacing the front plate [03061102-xx]" [}35]
► Remove the screwed joint.
8.2 "Replacing the screwed joint" [}94]
Fig.57: Disconnecting the nozzles and hoses
► Pull the nozzle (1) off the DP drive.
► Pull the DP drive (2), together with the jaws, out
of the head.
CAUTION!
Do not pull on the black cover. This might break
if you do.
.
► Remove the hose(3) on both sides.
► Repeat these steps for all twelve DP drives.
Fig.58: Screws fastening the star
► Remove the twelve screws fastening the star.
These twelve screws are between the DP drives
in each case.
► Carefully pull the complete star assembly off the
star motor. While doing so, hold the star on the
SCS.