00197902-03_UM_X-Serie-S_EN.pdf - 第260页
5 Working with the machine User manual SIPLACE X-Series 5.3 Switching on the SIPLACE line From software version 710.0 Edition 12/2016 260 5.3.5 Action performed by machine st art button The action performed by the st art…
User manual SIPLACE X-Series 5 Working with the machine
From software version 710.0 Edition 12/2016 5.3 Switching on the SIPLACE line
259
5
Fig. 5.3 - 1 "Production" view after loading the station software (example of SIPLACE X4i shown)
The status field (see section 5.5.1, page 264) shows the current status of the station and the action
to be performed.
Press the start button when you see the request "Press Start button".
Start buttons can be found on the input side, output side and on the operating panels to the
left and right of the station.
A reference run will be performed. After completion of this reference run, the station is ready
for operation.
The icon will be shown in the working area of the user interface (enabled).
5 Working with the machine User manual SIPLACE X-Series
5.3 Switching on the SIPLACE line From software version 710.0 Edition 12/2016
260
5.3.5 Action performed by machine start button
The action performed by the start button can be set.
Open the "Check sensors and functions" view (see section 5.5.3, page 265).
The following settings are possible:
Start production automatically 5
Standard setting.
Pressing the start button automatically begins the production process.
Do not change production status 5
This is used, for example, to calibrate and test the machine
Pressing the start button simply closes the electricity circuit; production is not started immediately.
5
5.3.6 "Switching on the SIPLACE line" flow chart
The following flow diagram shows the actions performed after the SIPLACE line has been
switched on.
CAUTION
Machine functions can be directly started via the GUI, irrespective of the start button set-
ting. If the electrical circuit has already been closed, you do not need to confirm with the
start button again.
User manual SIPLACE X-Series 5 Working with the machine
From software version 710.0 Edition 12/2016 5.3 Switching on the SIPLACE line
261
5
Fig. 5.3 - 2 Flow chart - switching on the "SIPLACE line"
Station computer
Switch on
Check setup
(configure feeder modules
Teach fiducials
Load board data
Press start button
Wait for reference run
Move board in
Wait for PCB
Check setup
(if table marked red
If required: change nozzle configuration
Nozzle check
Fiducials
OK?
Track error
Placement
Check setup
Fill up tracks
Placement
PCB in output conveyor
Italics: Performed or reported by the station
Yes
Yes
No
No
Presettings at machine
Download assistant
Programming system
Tasks
Confirm conversion in download
assistant
Bold lettering: job to be performed by op-
erator