00197902-03_UM_X-Serie-S_EN.pdf - 第76页
2 Operational safety User manual SIPLACE X-Series 2.4 Safety instructions for transporting the machine From software version 710.0 Edition 12/2016 76 2.4 Safety instructions for transporting the machine 2 Use a fork-lift…
User manual SIPLACE X-Series 2 Operational safety
From software version 710.0 Edition 12/2016 2.3 Classification of camera systems
75
2.3 Classification of camera systems
2.3.1 Classification of the whole machine
2
2.3.1.1 Laser classification
The following modules are assigned to laser class 2:
2
The following modules are assigned to laser class 3B:
2
2.3.2 Classification of the camera systems
2
The operational machine as a whole is classified as laser class 2.
The laser classes are determined according to IEC 60825-1:2014.
Assembly Data
Component sensor on SpeedStar Maximum optical output power: < 1 mW
Wavelength: 635 nm
Component sensor on MultiStar Maximum optical output power: < 1 mW
Wavelength: 635 nm
Laser light barrier on PCB conveyor Maximum optical output power: < 1 mW
Wavelength: 650 nm
1D board barcode reader
(Datalogic DS1500)
Maximum optical output power: --
Wavelength: 658
Assembly Data
3D coplanarity laser module Maximum optical output power: 60 mW
Wavelength: 670 nm
See also section 6.10
3D coplanarity laser module,
page 379
.
PLEASE NOTE
The camera illumination system used has bright LEDs fitted. These are classified as risk
group 1, according to IEC 62741:2006.
Do not look into beam!
2 Operational safety User manual SIPLACE X-Series
2.4 Safety instructions for transporting the machine From software version 710.0 Edition 12/2016
76
2.4 Safety instructions for transporting the machine
2
Use a fork-lift truck with the following specification to carry the machine:
Fork length: Min. 1800 mm
Carrying power: Min. 6,000 kg
Clear width between forks: Min. 350 mm 2
2
WARNING
Risk of tilting!
Risk of tilting, if the required specifications for the fork-lift truck are not observed.
Only use the specified fork-lift for transportation.
Transportation of the machine is described in chapter 4
, section 4.1, page 205.
User manual SIPLACE X-Series 2 Operational safety
From software version 710.0 Edition 12/2016 2.5 Safety instructions for operating the machine
77
2.5 Safety instructions for operating the machine
2.5.1 Safety instructions for closing the protective covers
To avoid risk of injury when closing the protective covers on the machine, the operator must in-
struct the personnel concerned to always follow the instructions below when handling the protec-
tive covers.
2
2
Fig. 2.5 - 1 Safety instructions for closing the protective covers (example of SIPLACE X2 S / X3 S / X4 S shown)
(1) Grab handles
To open or close the protective covers, always take hold of these by the grab handles.
When closing, do not reach into the gap between the protective cover and the machine panel.
When closing the protective cover, make sure that the area in which it is swiveled is free of
obstruction and that no other people are at risk of injury.
CAUTION
Risk of crushing hands!
Risk of crushing hands if the protective covers are not closed correctly.
Close the protective covers correctly.
(1)