00197902-03_UM_X-Serie-S_EN.pdf - 第282页
5 Working with the machine User manual SIPLACE X-Series 5.8 Shift changeover From software version 710.0 Edition 12/2016 282 5.8.2 Safety instructions for em ptying the waste t ape cont ainer 5 Fig. 5.8 - 1 Safety instru…
User manual SIPLACE X-Series 5 Working with the machine
From software version 710.0 Edition 12/2016 5.8 Shift changeover
281
5.8 Shift changeover
5.8.1 Shift changeover tasks
Splice the tapes early. The feeder modules do not have to be refilled as soon as the new shift
starts. This minimizes extended down times.
At the shift change, pass important information on to the next operator. This includes, for in-
stance, changes to the placement program. Also read through the list of the descriptions of
the steps to take in section 5
, page 303.
Carry out a setup check.
Make sure that the feeder modules are equipped with the correct components, that they are
at the correct locations in the component trolley and that the conveyor increment is set cor-
rectly.
Clean the following line assemblies:
Empty the reject bin and carefully vacuum the area around the reject bin.
Carefully vacuum the nozzle changer, feeder modules and the component trolley.
Empty the waste tape container. Follow the safety instructions given in section 5.8.2, page
282
.
Empty the tray for the machine cover.
5 Working with the machine User manual SIPLACE X-Series
5.8 Shift changeover From software version 710.0 Edition 12/2016
282
5.8.2 Safety instructions for emptying the waste tape container
5
Fig. 5.8 - 1 Safety instructions for emptying the waste tape container
The waste tape container must be pulled out of the component trolley for emptying. There is a risk
of catching your thumbs as you do so.
To avoid this risk, take hold of the underside of the grab recess on the waste tape container
with your fingers and place your thumbs on top of the grab recess.
Do NOT put your thumbs in the gap between the tape container and waste tape container as
you could catch your thumbs if you do.
User manual SIPLACE X-Series 5 Working with the machine
From software version 710.0 Edition 12/2016 5.9 Carrying out a sight check
283
5.9 Carrying out a sight check
5.9.1 Checking the X feeder modules
5
Fig. 5.9 - 1 Checking the X feeder modules
(1) Flap
(2) Blade
(3) Status display
(4) LCD display
5
Check to see whether the tape foil removal container for the X tape feeder module is full.
Open the flap (item 1). Pull out the cover foil and cut it with scissors or on the integral blade
(item 2) on 8 and 12 mm X tape feeder modules.