00197902-03_UM_X-Serie-S_EN.pdf - 第304页

5 Working with the machine User manual SIPLACE X-Series 5.12 Changing the setup From software version 710.0 Edition 12/2016 304 5.12 Changing the setup 5.12.1 Printing out the conversion inst ructions before changing the…

User manual SIPLACE X-Series 5 Working with the machine

From software version 710.0 Edition 12/2016 5.11 Observing displays on the X feeder module

303

Reference o

Red Position information is no

longer available for the com-

ponent tape drive

Remove the component tape (tape can be

moved out by pressing the arrow keys or

pulled out after raising the pick-up window).

Then press the "FOIL" button to start the

reference run.

CAN BusError

(CAN bus error)

Red CAN bus error Log off and on again, check the optical fiber

interface

ParNotSaved! Red Parameters were not saved Default parameters are loaded automatical-

ly, i.e. the most recent operator settings are

overwritten -> The settings (e.g. increment)

will have to be made again. Replace the

control board if this error occurs frequently.

ParWrongSave Red Wrong or incomplete param-

eters were saved

BootFlashErr

FlashDataErr

Red Can no longer write to boot

or application memory cor-

rectly

Replace the feeder module or control board

PLEASE NOTE

 Remove the component tape before a reference run.

Text on the

LCD display

Status

display

Meaning Solution

5 Working with the machine User manual SIPLACE X-Series

5.12 Changing the setup From software version 710.0 Edition 12/2016

304

5.12 Changing the setup

5.12.1 Printing out the conversion instructions before changing the setup

Before a change of setup, print out the conversion instructions on the printer for the SIPLACE Pro

computer as described in the "SIPLACE Pro" manual or in the online help.

5.12.2 What you should note when changing the feeder modules

 Handle the feeder modules carefully when you insert them into or remove them from the

changeover table. Make sure that the X feeder modules do not bump against the centering

bar (see item 5 in fig. 5.10 - 3

, page 292) of the changeover table.

 Vacuum the supporting surfaces of the feeder modules and clean the surface of the table

when necessary according to the instructions in the preventive maintenance manual.

 Remove loose components using a brush or a vacuum cleaner with a suitable nozzle.

CAUTION

Risk of injuries!

Fine metal splinters from components could injure hands.

 Avoid removing components from the changeover table with your fingers.

User manual SIPLACE X-Series 5 Working with the machine

From software version 710.0 Edition 12/2016 5.13 Avoiding track errors

305

5.13 Avoiding track errors

5.13.1 General

 Make sure that the areas around the feeder modules are clean and that there are no loose

components in the feeder area or under the feeder modules.

 Refill promptly with components.

 Splice the tapes early. This generally means that you are to prepare the splicing material

when there is still approximately 1.5 m of tape on the reel.

 Handle the feeder modules carefully when you insert them into or remove them from the

changeover table as these are high-precision devices.

 For X feeder modules, lower the pickup window since it can easily be damaged when raised.

 Check that the pick-up position is set correctly for the components on the feeder modules.

5.13.2 Avoiding track errors with the tape container

 Insert the separating plates correctly (see fig. 5.9 - 3, page 287).

PLEASE NOTE

A raised pick-up window leads to noticeably impaired pick-up quality.