80S-15贴片机.pdf - 第440页
9 Revolver Head SIPLACE 80S/F/G Service M anual Edition 04/97 9 - 156
SIPLACE 80S/F/G Service Manual 9 Revolver Head
Edition 04/97
9 - 155
9.21.4 Replacing the vacuum nozzle
●
Disconnect the compressed air hose from the vacuum nozzle.
●
Replace the vacuum nozzle (see item 5 in Fig. 9.21.1).
●
Carry out a function test using the SITEST program.
9.21.5 Replacing the distributor and O-rings
●
Dismantle the encoder housing as described in Section 9.13 on page 9 - 103.
●
Pull the distributor (item 8 in Fig. 9.21.1) out of the hole in the lifting carriage housing.
●
Replace the O-rings (see items 9 and 10 in Fig. 9.21.1).
●
Insert a new distributor, if necessary.
●
Fit the head and then carry out a function test using the SITEST program.
9 Revolver Head SIPLACE 80S/F/G Service Manual
Edition 04/97
9 - 156
SIPLACE 80S/F/G Service Manual 9 Revolver Head
Edition 04/97
9 - 157
9.22 Service work on the PCB camera
9.22.1 Tools, equipment and consumables
9.22.2 Spare parts
9.22.3 Dismantling the PCB camera
DANGER
OOO
Switch the placement machine off at the main switch and disconnect from the power supply.
●
Remove connector X1 of cable Y0577 (point 5 in Fig. 9.22.1) from terminal X1 on board Y0029.
●
Remove connector X3 (point 6 in Fig. 9.22.1) of the lens system lighting cable from terminal X2 on board
Y0029.
●
Remove connector X1 of the PCB camera cable Y0597 (see item 2 in Fig. 9.22.1) from the PCB camera
amplifier.
●
Dismantle the red retaining bracket.
●
Loosen the 4 M3 hexagon socket-head screws (see item 6 in Fig. 9.22.2) for fixing the PCB camera holder
(see item 5 in Fig. 9.22.2).
From item number
Set of hexagon socket-head screwdrivers
Diagonal cutter
Cable ties
SITEST program
Number in
Fig. 9.22.1.
From item number
PCB camera, type A (SIPLACE 80S, 80F, gantry 1)
1 and 8 02102978-01
PCB camera, type B (SIPLACE 80S, gantry 2)
1 and 8 00130380-01
Illumination control for the PCB camera
7 00301388-01
Cable: Pulnix camera conversion board Y0597
9 00305674-03