Dual Simultaneous Programmable Pitch Rev 02.pdf - 第13页

Dual-Simultaneous Pr ogrammable Pitch Owner ’s Manual In stallation and Configuratio n © 2024 Nordson Corporation 9 3.6 Adjusting Applicator Height ? NOTE Applicators shou ld be a t the same height . Applicator height is…

Dual-Simultaneous Programmable Pitch Owner’s Manual Installation and Configuration

3.5 Adjusting Limit Sensor

To adjust the limit sensor (Figure 3-1):

1. Loosen the two (2) screws on the front of the limit sensor.

NOTE

There are nuts on the back of each screw. Do not loosen the screws too much or

the nuts will off.

2. Slide the limit sensor to the appropriate position, depending on which applicator is

configured for the coating system, see Table 1-1.

3. Tighten the two (2) screws on the front of the limit sensor.

NOTE

The limit sensor may need to be adjusted after installing the applicator to prevent

applicators from colliding when traveling to the narrowest pitch.

Item Description

1 Limit Sensor

2 Screws (2)

Figure 3-1 Position Limit Sensor

Dual-Simultaneous Programmable Pitch Owner’s Manual Installation and Configuration

3.6 Adjusting Applicator Height

NOTE

Applicators should be at the same height. Applicator height is changed by adjusting

the height of the applicator bracket.

To adjust applicator height (Figure 3-2):

NOTE

The height adjustment screws must be used in conjunction. Do not tighten one without

loosening the other. When finished, the height adjustment screws and side setscrew

must be tight against pivot.

1. Install the applicable applicators, refer to the applicable applicator manuals.

WARNING!

When installing, performing maintenance, or making adjustments with power on,

do not hot swap the Pitch Motor and Pitch ENC and Sensors cables on the

Z-head (Figure 3-5).

2. Loosen, do not remove, the side setscrew.

3. To raise the applicator bracket, loosen the bottom height adjustment screw and tighten the

top height adjustment screw.

4. To lower the applicator bracket, loosen the top height adjustment screw and tighten the

bottom height adjustment screw.

5. Tighten the side setscrew.

Dual-Simultaneous Programmable Pitch Owner’s Manual Installation and Configuration

Top Height Adjustment Screw

Bottom Height Adjustment Screw

Item Description Item Description

1 Top Height Adjustment Screw 3 Applicator Bracket

2 Bottom Height Adjustment Screw 4 Side Setscrew

Figure 3-2 Adjust Applicator Height