SIPLACE X-Series (SIPLACE X-Series S, from SC 708.1) Edition 05/2015 EN User manual.pdf - 第297页
User manual SIPLACE X-Series 5 Working with the machine From software version 708.1 Version 05/2015 5.9 Carrying out a sight check 297 X-Series feeder modules can pr ocess component tap es without problems if the lateral…
5 Working with the machine User manual SIPLACE X-Series
5.9 Carrying out a sight check From software version 708.1 Version 05/2015
296
5.9.3 Checking the PCB supports
Check the position of the magnetic PCB supports on the lifting table:
– Make sure that the PCB supports do not collide with components on the underside of the
PCBs.
– In addition, make sure that the PCB supports do not collide with the PCB conveyor pan-
els.
– Only use PCB supports as described in section 6.14
, page 399.
5.9.4 Mount of additional tape reel
5
Fig. 5.9 - 2 Mount of additional tape reel
(1) Mount of additional tape reel, item no. 00141217-xx
(2) Mounting device for the support
5
Max. 60 mm
User manual SIPLACE X-Series 5 Working with the machine
From software version 708.1 Version 05/2015 5.9 Carrying out a sight check
297
X-Series feeder modules can process component tapes without problems if the lateral offset be-
tween the feeder module and the tape reel does not exceed 60 mm.
If a predefined setup means that the maximum permitted offset cannot be maintained, we recom-
mend that you use the mount for an additional tape reel (item 1). Simply insert the mount into the
holder (item 2) and push it until the offset is less than the maximum permitted value of 60 mm. The
component trolley has 5 holders in total. Each tape reel mount can hold 2 tape reels, which means
that up to ten 15" (381 mm) reels can be positioned above the tape container.
5.9.5 Inserting separating plates into the tape container
The separating plate has different edges and can be inserted into the tape container in two
ways. If spindles are used, the recesses for the spindles in the separating plate point upwards
(see item 4 in fig. 5.9 - 3
). If you do not use spindles, the rounded edge of the separating
plate points up (see item 5 in fig. 5.9 - 3
).
Insert the separating plates as shown in fig. 5.9 - 3 and remember that the smallest division
of the tape container is a 2x division. This will help avoid placement errors.
Check that the separating plates engage in the same positions on the three guide rails. Oth-
erwise the separating plate will be offset or bent.
5 Working with the machine User manual SIPLACE X-Series
5.9 Carrying out a sight check From software version 708.1 Version 05/2015
298
5
Fig. 5.9 - 3 Separating plates in the tape container
(1) Guide rail for the separating plates
(2) Waste tape container
(3) Tape container
(4) Position of the separating plate if spindles are used
(5) Position of the separating plate if no spindles are used
(6) Sliding support for tape reels