M3plus_OperationManual_e.pdf - 第115页
3 - 50 3 Creating the PCB data 4. Creating the component information 4 Set "Feeder Type" of the Basic parameters. Set "Feeder Type" according to the stick feeder type you will use. Select "Feeder…
3 -49
4. Creating the component information
3
Creating the PCB data
4.10 Using component feeders other than tape feeders
4.10.1 Setting the stick feeder component data
When using stick feeder components (except for multi-stick feeders), make the following
settings in the component information.
1
Set the stick feeder on the feeder plate.
Install the stick feeder on the feeder plate, at a position that meets the following two
conditions.
1.Within the working range of the moving camera
The moving camera is used for teaching of the component pickup point.
2.On the front feeder plate
The component information is specified based on the component supply from the
front feeder plate.
2
Select the component data.
Open the [Parts] screen, and line up the cursor with the data line of the component
which is supplied by the stick feeder.
Selecting the component
27432-5E-20
3
Set "Package" of the Basic parameters to "Stick".
On the [Basic] tab screen, set the "Package" parameter item to "Stick".
3 -50
3
Creating the PCB data
4. Creating the component information
4
Set "Feeder Type" of the Basic parameters.
Set "Feeder Type" according to the stick feeder type you will use.
Select "Feeder Type".
Select "Feeder Type".
27433-5E-20
High-speed stick feeder
Select from among "HS-Stick-L06", "HS-Stick-L09", "HS-Stick-L13", "HS-Stick-L16", "HS-Stick-
L20" and "HS-Stick-L26". (Each number indicates the length of the component.) For other high-
speed stick feeders, select from "HS-Stick-A" to "HS-Stick-D".
Stacked stick feeder
Select from among "StackStk-L06", "StackStk-L09", "StackStk-L13", "StackStk-L16", "StackStk-
L20" and "StackStk-L26". (Each number indicates the length of the component.) For other stacked
stick feeders, select from "StackStk-A" to "StackStk-D".
n
NOTE
Stack stick feeders can only be used with machines designed for large tape feeders. Mutli-stick feeders are not
supported.
5
Set "Feeder Set No." of the Pick parameters.
Enter the number of the feeder set position at which the stick feeder knockpins are
inserted into the feeder plate.
Enter the feeder set position.
Enter the feeder set position
27434-5E-20
3 -51
4. Creating the component information
3
Creating the PCB data
6
Set "Position Definition" of the Pick parameters.
Set this parameter to "Automatic" when using a stick feeder.
n
NOTE
The "Position Definition" parameter specifies the method for obtaining the coordinates of a component pickup
position.
When "Automatic" is selected, the machine automatically calculates the pickup position based on the feeder plate
reference position. Select this setting when using components whose pickup position is independent of the
component size, such as tape feeders.
7
Set the Tray parameters.
Open the Tray tab screen and set each parameter as follows.
• Comp. Amount:
Enter the number of components loaded into a single stick.
• Current Pos.:
This shows the number of components which have been used from the stick. Use
the initial setting value.
• CountOut Stop:
Normally, set this parameter to "Nothing". If this is set to "Exist", the machine will
automatically stop when the number of components set in the Comp Amount
parameter have been used up.
Tray parameter setting
27437-5E-20