M3plus_OperationManual_e.pdf - 第218页
B Alignment T ype glossar y B - 5 2. Alignment T ype glossar y 2.1 Alignment Type Refer to the table below when setting the Alignment Type parameter on the [Parts]- [Basic] tab. Box type chip Cylindrical chip (Melf type)…
A -4
A
Specifications
1. Specifications
1.3 Power connection terminals
The power connection terminals are located inside the lower left panel on the rear of the
machine. Connect the power cable leads as shown below to the primary terminals L1 and
L2 on the main breaker and the ground terminal on the main unit chassis.
Power
Power supply specifications
Frequency Power capacity
Single phase AC 200 to 240V -10%, +6% 50/60Hz 2.8kVA
25111-5E-20
Power input terminal
Ground terminal
Main breaker
Power connection terminals
Breaker
23126-5E-20
Earth
Green
L=350mm
L=350mm
Round crimp terminal
Crimp terminal with insulation tube
L1
L2
Power cable example
23127-5E-20
c
CAUTION
Use a power cable that uses conductor wire having a cross section of at least 3.5mm
2
(AWG13).
w
WARNING
TO AVOID THE RISK OF ELECTRICAL SHOCK, MAKE SURE THAT THE POWER SOURCE IS
OFF BEFORE CONNECTING THE POWER CABLE. ALSO MAKE SURE THAT THE GROUND
CABLE IS SECURELY CONNECTED TO THE MACHINE.
B
Alignment Type glossary
B -5
2. Alignment Type glossary
2.1 Alignment Type
Refer to the table below when setting the Alignment Type parameter on the [Parts]-
[Basic] tab.
Box type chip
Cylindrical chip
(Melf type)
BGA
Bare chip
Lead width
Alignment type setting
Chip, Ball lead component
Component type Alignment Type
Normal box type chip
Box type chip not recognized as standard chip
Box type chip whose lead width does not
match the chip width, such as tantalum capacitor
For small chip whose reflecting area is smaller
than actual area during recognition
Melf chip component
Chip component with no square part and fed
in vertical direction
Normal BGA
Flip chip
Mold body is shiny type such as ceramic
Normal bare chip
Std.Chip
Sp.Chip
Odd.2Ends
Small Chip
Melf Chip
Cylinder
BGA
Simple BGA
FlipChip
Odd.Chip
Bare.Chip
25003-5E-20
B -6
B
Alignment Type glossary
2. Alignment Type glossary
Component with leads protruding
from one direction.
Component with leads protruding
from two directions
and the number of leads diagonally
positioned is different.
Component with leads protruding
from two directions
and the numbers of lead diagonally
positioned is the same.
Component with leads protruding
from four directions
and the number of leads diagonally
positioned is the same.
Component with leads protruding
from four directions
and the number of leads diagonally
positioned is different.
Component with leads protruding
from one direction.
Oppositely positioned lead shapes
are the same
Oppositely positioned lead shapes
are different
Lead protrudes out from
molded body
Lead does not protrude out from
molded body
Lead protrudes out from
molded body
Lead does not protrude out from
molded body
Lead shape differs in
each direction
Number of leads is insufficient
Lead shapes are different in
one direction
Alignment type setting
Lead component, Nonstandard
Component type Alignment Type
Con-E
Mini-Tr/SOT
P-Tr/Con-NS
SOP
SOJ
QFP
PLCC
Con-NSEW
OffLead
Special
25004-5E-20