00196497-07_SM_SXDX12_en.pdf - 第117页

Service Work Conveyor 3.4.21 Replacing the Guide C arriage/Loose Bearing Gantries Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02 117 3.4.21 3 . 4 . 2 1 R e p la c in g t h e G u id e C a r r ia g e / L o o s e B e a r in g …

Service Work Conveyor

Gantries 3.4.20 Replacing the Head Adapter for the HCU and MHCU/HCU

116 Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02

► If you have ordered the base adapter without HCU(s) you will have to convert the HCU(s).

Remove the two screws fastening the HCU on the underside of the board and carefully pull the HCU

off the base adapter. Make sure not to damage the pins located below. Repeat this procedure for the

second HCU, if necessary (for TwinHead only).

Installation

► Follow the removal instructions in reverse order for installation. Also observe the following instruc-

tions:

See also

 5.2.5.2 Base adapter TWIN [03055517-xx] [ ➙ 319]

 5.2.5.1 Base adapter C&P [03055516-xx] [ ➙ 317]

Head adapter HCU (here the TwinHead version)

► Unplug all electrical connections. You may want to

mark their positions, to make clear assignment easier

later on.

► Remove the two front screws (1) fastening the HCU

in each case. Make sure that you do not lose the

shims. Make a note of the number of washers used

for each screw, as this may well differ.

► Undo all the screws (2) fastening the board and then

remove the board.

CAUTION

Installation instructions

► Check the firmware and perform a download, if needed. (See "4.9.1 Firmware Download

(SW 70x)" [ ➙ 293])

Service Work Conveyor

3.4.21 Replacing the Guide Carriage/Loose Bearing Gantries

Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02 117

3.4.21

3.4.21 Replacing the Guide Carriage/Loose Bearing

Replacing the Guide Carriage/Loose Bearing

Magnets - Danger of Crushing

Guide carriage on the gantry

NOTE: T his task ma y only be performe d by SIPLACE serv ice techni cians.

DANGER

Danger of crushing

The attraction force of the magnets is 400 Nm.

1 Screws fastening the guide carriages 2 Loose bearing Y-axis

3 Loose bearing X-axis

CAUTION

Do not remove the screws

Removing the screws fastening the guide carriages or the loose bearings leads to tensions that

have a negative effect on the working life of loose bearings, guide carriages, and guide rails.

NOTICE

SIPLACE Service

This task may only be performed by SIPLACE service technicians.

Service Work Conveyor

Gantries 3.4.22 Replacing the Y Linear Motor (Primary Part)

118 Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02

3.4.22

3.4.22 Replacing the Y Linear Motor (Primary Part)

Replacing the Y Linear Motor (Primary Part)

Magnets - Danger of Crushing

NOTE: T his task ma y only be performe d by SIPLACE serv ice techni cians.