00196497-07_SM_SXDX12_en.pdf - 第83页
Service Work Conveyor 3.3.8 Replacing the CAN Switch [03083844-xx] Control Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02 83 Removal ► Switch off the machine, disconnec t it from the po wer supply and secure it to prev ent …
Service Work Conveyor
Control 3.3.8 Replacing the CAN Switch [03083844-xx]
82 Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02
3.3.8
3.3.8 Replacing the CAN Switch [03083844-xx]
Replacing the CAN Switch [03083844-xx]
SXDX12V1V2
Parts, Equipment and Tools
▪ CAN switch [03083844-xx]
Overview
SXDX12V1 V2 – Installa tion Location
NOTICE
On machines up to no.: Mxxx only
The CAN switch is only used in machines up to serial nos.: Mxxx.
Description CAN 1
1. RESET – button
The button is used to reset the red LED on both sides,
CAN 1 and CAN 2.
2. LED green: setting 1Mbit
LED red: setting 500kBit
3. CAN bus cable connection CAN 1
4. LED green/red for CAN 1
Data transfer OK: green
Error frames received: red
Description CAN 2
1. LED green/red for CAN 2
Data transfer OK: green
Error frames received: red
2. CAN bus cable connection CAN 2
3. Voltage supply connection 24 V DC
Service Work Conveyor
3.3.8 Replacing the CAN Switch [03083844-xx] Control
Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02 83
Removal
► Switch off the machine, disconnect it from the power supply and secure it to prevent unauthorized
reactivation. Observe the instructions in section "1.2 Preparatory Work..." [ ➙ 13].
► Unplug the electrical connections for the CAN switch. Mark their positions, to make clear assignment
easier later on.
Installation
► Follow the removal instructions in reverse order for installation. Also observe the following instruc-
tions:
CAUTION
Installation instructions
► Correct/check the DIP switch setting on the CAN switch (see "4.3.5 Setting the DIP Switch
on the CAN Switch" [ ➙ 261]) (default setting: X-Series S).
Service Work Conveyor
Gantries 3.4.1 Replacing the Gantry Assembly [03061618-xx]
84 Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02
3.4
3.4 Gantries
Gantries
3.4.1
3.4.1 Replacing the Gantry Assembly [03061618-xx]
Replacing the Gantry Assembly [03061618-xx]
NOTICE
40 mm gantry for Twin VHF
In addition to the standard gantry, there is also a special 40 mm gantry available for the Twin
VHF. Unless otherwise specified, all work is described using the example of the standard gan-
try. Any relevant differences will be mentioned explicitly.
NOTICE
Assembly instructions
Read the corresponding instructions:
► Assembly instructions "Gantry Modularity - SIPLACE SX1/SX2" [00196626-xx]