00196497-07_SM_SXDX12_en.pdf - 第213页

Service Work Conveyor 3.10.2 Replacing the SX1/SX2 Component Trolley Feed Device Asse mbly [03059353-xx] COT insert Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02 213 Checking the downholder positions ► Move the component t…

100%1 / 334
Service Work Conveyor
COT insert 3.10.2 Replacing the SX1/SX2 Component Trolley Feed Device Assembly
212 Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02
Fitting the left downholder
► Loosen the two screws (4) and (5) on the left side of the COT insert.
► Place the "downholder COT-i left assembly" [03085800-xx] on the left side of the COT insert so that
the holes are aligned with one another.
► Screw the downholder tight with the two new screws (4) and (5).
► The downholder pin (2) must always be approx. 10 mm before the claws of the insert and the dock-
ing aid (3), behind the machine protection (cover flap).
NOTICE
COT-I30 insert for the WPC
When using a COT-I30 insert for the WPC, you only need to fit the downholder on the right.
1 Pin DIN6325-10-M6x30-St [00358814-xx]
at position inside
2 Pin DIN6325-10-M6x30-St [00358814-xx]
at position outside
3 Docking aid 4 Screw ISO4762-M8x40-A2-70 [03042589-
xx]
5 Screw ISO4762-M8x40-A2-70 [03042589-
xx]
Service Work Conveyor
3.10.2 Replacing the SX1/SX2 Component Trolley Feed Device Assembly [03059353-xx] COT insert
Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02 213
Checking the downholder positions
► Move the component trolley back into the machine.
► The component trolley height must be adjusted so that the side rails fit into the recess on the docking
aid (1). (See also "4.8.1 Setting the Changeover Table Height" [ ➙ 292])
1Docking aid
Service Work Conveyor
COT insert 3.10.2 Replacing the SX1/SX2 Component Trolley Feed Device Assembly
214 Service Manual SIPLACE SX1/SX2/DX1/DX2 FS02
► After pulling the table in through the cylinder, the downholder pin (1) should be up, against the com-
ponent trolley downholder (2).
1 Downholder pin on the docking aid 2 Component trolley downholder
NOTICE
Wear
In the event of frequent component trolley cycle changes, these parts may become worn. Both
the downholder pin and the component trolley downholder are available as spare parts.