BM料架治具使用手册.pdf - 第79页
Feeder Inspection Unit 5.1 Daily Check Items 5.1−4 DX1OEC−80−070−A0 = MEMO =
Z slider
Feeder side
Bolt
(Loosen the bolt
during adjustment and
tighten when fixing the
camera.)
Nameplate
Rotate the
camera.
5.1 Daily Check Items
Feeder Inspection Unit
5.1−3
DX1OEC−80−070−A0
3. Loosen the bolt for locking the camera of the Z
slider to enables the camera to be rotated.
While observing the display on the monitor, turn
the camera until the gauge holes V
L
and V
R
match. Then, tighten the bolt to secure the
camera.
=REMARKS=
Install the camera so that the nameplate
can be placed on the feeder side as shown
in the drawing right.
Two marks appear to be misaligned.
Adjust so that two
marks overlap.
OK (After adjustment)
Positioning is OK if two holes overlap.
NG (Adjustment is required.)
=CHECK=
Perform the procedure in ‘" Checking the Camera Position’ again to make sure the camera for
proper position. If there is nothing wrong with the adjustment, complete the setting.
Feeder Inspection Unit
5.1 Daily Check Items
5.1−4
DX1OEC−80−070−A0
= MEMO =
5.2 Routine Check Item
Feeder Inspection Unit
5.2−1
DX1OEC−80−080−A0
5.2 Routine Check Item
DX1OEC−80−080−A0
Sentence No.
No. Check Item Check method and point Check period
1 Check gauge jig
accuracy
• Check the installation accuracy of the block and
guide pin.
Once a year
2 Camera LED check
and replacement
• If the intensity is insufficient even after the LED is
adjusted, replace the LED.
When the intensity
is weak, replace
the LED after about
10,000 hours of
use.
3 Lubrication
• Lubricate the movable parts regularly.
Refer to ‘5.3.3’ and
‘5.3.4’.