BM料架治具使用手册.pdf - 第88页
5.3 Lubrication Feeder Inspection Unit 5.3−5 DX1OEC−80−140−C0 5.3.4 Clamp Stand 3 2 1 Oiling No. Oiling point Oil type Oil volume Period Lubrication method 1 Bracket MP grease Moderate amount 3 months Apply oil thinly to…
Feeder Inspection Unit
5.3 Lubrication
5.3−4
DX1OEC−80−140−C0
Feed Screws
• Apply grease entirely to
the thread and wipe off any
excess with a waste cloth.
Thread
Thread
Feed screw (Y)
Feed screw (X)
Feed screw (Z)
T
hread
=HINT=
It is not necessary to disassemble the unit for lubrication.
Bearing
As shown in the drawing below, fill proper amount of oil from the both sides (x 3 points)
Bearing
5.3 Lubrication
Feeder Inspection Unit
5.3−5
DX1OEC−80−140−C0
5.3.4 Clamp Stand
3
2
1
Oiling
No. Oiling point Oil type
Oil
volume
Period Lubrication method
1 Bracket MP grease
Moderate
amount
3 months
Apply oil thinly to the sliding
parts.
2 Shaft MP grease
Moderate
amount
3 months
Apply oil to the surfaces that
touch the bearing.
3 Guide plate
Machine oil
(Antirust)
Thinly
When
storing
for
extended
period
Apply thinly to the top of the
plate and guide surfaces on
the side.
Feeder Inspection Unit
5.3 Lubrication
5.3−6
DX1OEC−80−140−C0
Bracket
=HINT=
It is not necessary to disassemble
the unit for lubrication.
Apply oil slightly to the areas marked .
Shaft
Apply to the surfaces that touch the bearing.
=HINT=
It is not necessary to
disassemble the unit for
lubrication.
Guide Plate
Apply thinly to the area marked .
Top surface
Apply oil to the side
surface as well.
=HINT=
It is not necessary to disassemble
the unit for lubrication.