EUKYX-199-4110_G5S2_Instruction_Vol4_E.pdf - 第118页
EUKYX 1-69 199-4100 5.6 Hydraulic Cleaning Machine • For using the nozzle t ip cleaning jig A j ig for c leani ng HG2 4C or HG3 3C from the tip w ith a pi n ga uge , is pro vided. Pin Gauge Nozzle Nozzle Tip Cleaning Jig…
EUKYX
1-68199-4100
5.5 Cleaning of high-speed nozzle hole part with pin gauge
(3) Move the pin gauge to the direction of the length hand of pick-up hole and remove the
internal clog.
Pin gauge
High-speed nozzle
F4A52
(4) Blow air and blow away removed dirt (Stick and remove the fine dirts of the high-speed
nozzle head by the masking tape).
High-speed nozzle
Masking tape
F4A53
EUKYX
1-69199-4100
5.6 Hydraulic Cleaning Machine
• For using the nozzle tip cleaning jig
A jig for cleaning HG24C or HG33C from the tip with a pin gauge, is provided.
Pin Gauge
Nozzle
Nozzle Tip Cleaning Jig
F4A54
Insert the nozzle from the tip section into the jig and insert the pin gauge gently into the nozzle tip
hole with the nozzle pressed against the jig.
In the case that the pin gauge is not easily inserted, do not insert it forcibly, but repeat the pin
gauge moving up and down.
5.6 Hydraulic Cleaning Machine
A commercially available hydraulic cleaning machine can be used.
Example : MAC3 III (Maker : Nakamura Cyoukou)
When the hole is clogged with solder paste, the cleaning might not be available.
Clean it also with the pin gauge. After the cleaning, dry it completely with air-blow or dryer.
Note
EUKYX
1-70199-4100
5.7 Nozzle Filter Insertion Procedure
5.7 Nozzle Filter Insertion Procedure
• Filter replacement jig
There are 2 filter replacement jigs: for High-Speed Nozzle and for Nozzle picking up Middle-
Size/Odd-Shape component. The same procedures apply to both jigs.
For Nozzle picking up
Middle-Size/Odd-Shape
component
For High-Speed Nozzle
Nozzle set position
F4A83
(1) Set the nozzle filter in the nozzle filter set position with tweezers or similar tool.
Nozzle filter set position
F4A58A
(2) Set the acrylic block on the nozzle filter set position.
Acrylic block
(for holing filter)
Acrylic block set on nozzle filter set position
Nozzle filter set position
F4A59A
Note
Procedure