EUKYX-199-4110_G5S2_Instruction_Vol4_E.pdf - 第72页
EUKYX 1-23 199-4100 4.3 Component Recognition Camera Section 4.3 Component Recognition Came ra Sec tion 4.3. 1 Component Recognition Camera Cleaning NOTICE Do not put your hand onto the reference mark block. If too much …
EUKYX
1-22199-4100
4.2 Vacuum System
4.2.2 Filter Cleaning
Cycle : Every 3 Months (Required Time : 10 minutes)
Filter Case
C
Filter
F4A15
(1) Remove 4 setscrews fastening the cover at the lower front of the machine and detach the
cover.
(2) Rotate the filter case in Arrow Direction C to detach and then take out the filter.
(3) Blow air to the filter for cleaning.
When the vacuum pressure has dropped during the operation, replace the filter with a new
one.
(4) Attach the cover while pushing it upward and tighten it with the setscrews.
If a clearance is left between the main machine and the cover, the tape will pop out from the
clearance during the operation, causing the machine to breakdown or generate an error.
Procedure
Note
Notice
EUKYX
1-23199-4100
4.3 Component Recognition Camera Section
4.3 Component Recognition Camera Section
4.3.1 Component Recognition Camera Cleaning
NOTICE
Do not put your hand onto the reference mark block.
If too much force is given to the reference mark
block, it may become deformed.
Use a suction force such as a vacuum cleaner for the cleaning.
Do not blow air to any cleaning section with an air gun.
When air is blown, the dirt and dust inside the machine will disperse, causing the recognition
system and the machine to malfunction.
Fiducial Mark Block
Component Recognition Camera
(2 locations)
Every Day Cleaning
Required Time: 4 minutes
Remove the components that have fallen with a
pair of vacuum tweezers and wipe off dust with
a lens cleaning cloth.
F4A16
Notice
EUKYX
1-24199-4100
4.3 Component Recognition Camera Section
4.3.2 Component Storage Box Cleaning
NOTICE
Before removing the accumulated components from
the box, eliminate the static electricity from your
body.
Otherwise, some components may be damaged due
to static electricity.
Fiducial Mark Block
Component Storage Box
Every Day Cleaning
Required Time: 1 minute
Remove components collected in the box.
• If foreign objects are adhered to a shielding
plate and a magnet at the bottom of the box,
remove them.
Hanenite (Vibration Proof Rubber)
Every Day Cleaning
Required Time: 1 minute
Take out Hanenite from the component storage
box and clean it with a vacuum cleaner.
F4A18
Component Storage Box Base
Every Day Cleaning
Required Time: 1 minute
In the case that there is any foreign object
dropped on to the base section, remove it.
Component Storage Box
Detection Sensor (Rear Side)
Every Day Cleaning
Required Time: 1 minute
Clean the sensor using a cotton swab.
F4A18-1