EUKYX-199-4110_G5S2_Instruction_Vol4_E.pdf - 第68页

EUKYX 1-19 199-4100 4.1 Air Source 4. 1 . 2 Main Air Pressure Inspec tion C yc le : Ever y Da y (Requir ed Time : 1 minute) Main Air Pressure F4A9 Visually che ck that t he set air pressure is 0.45 MPa (4. 6 kgf / cm 2 )…

EUKYX

1-18199-4100

4. Inspection, Cleaning, and Lubrication Spots

The following describes the maintenance tasks required for each individual units.

Refer to “2. Maintenance Check List” in this chapter for the maintenance items classiﬁed

based on frequency.

4.1 Air Source

4.1.1 Air Blow Pressure Inspection

Cycle : Every Day (Required Time : 1 minute)

Air Blowing Pressure

F4A8

Visually check that the pressure gauge reads the initial setting 0.05 MPa (0.5 kgf/cm

The pressure is factory-adjusted upon shipment of the machine.

Do not change the pressure unless necessary.

Reference

Procedure

Notice

EUKYX

1-19199-4100

4.1 Air Source

4.1.2 Main Air Pressure Inspection

Cycle : Every Day (Required Time : 1 minute)

Main Air Pressure

F4A9

Visually check that the set air pressure is 0.45 MPa (4.6 kgf/cm

) and "Min. 0.4 MPa (4.1 kgf/

)" while the machine is running. If not, adjust the set air pressure.

4.1.3 Drain Cleaning

Cycle : Every Week (Required Time : 5 minutes)

Cap

Drain

F4A10

Prepare a container and pull down the black cap each on the filter case lower section to drain.

Procedure

EUKYX

1-20199-4100

4.1 Air Source

4.1.4 Filter Cleaning

Cycle : Every 3 Months (Required Time : 5 minutes)

Filter

F4A11

(1) Turn the cover unit in the direction shown in the figure below, using the air-filter case

removing jig to remove the cover.

F4A12

(2) While rotating the filter holder counterclockwise, pull it out.

Filter Holder

F4A13

(3) Pull out the filter and blow air to it for cleaning.

(4) Insert the filter back in place and turn the filter holder clockwise to attach.

(5) Attach the filter cover.

When the ﬁlter has become defective, replace it with a new one.

Procedure

Note