PCBRM_User_Manual_R9.pdf - 第28页

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 3: Set Up & Installation Part No. 4005.00.906 3-2

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 3: Set Up & Installation

Part No. 4005.00.906 3-1

3: Set Up & Installation

3 Set Up & Installation ......................................................................................................................3

3.1 Leveling Module..............................................................................................................................................3

3.2 PCBRM15 – Carrier Arms Installation.......................................................................................................4

3.3 PCBRM System 5.2 - Carrier Arms Installation........................................................................................7

3.4 PCBRM System 5.2 – X Axis Stops, Set Up, Function...............................................................................8

3.5 PCBRM System 5.2 – Z Axis Stop, Set Up, Function ................................................................................9

3.6 PCBRM System 5.2 - Preheater Safety Stop.............................................................................................10

3.7 Optional Fume Extraction Manifold Assembly Installation...................................................................11

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 3: Set Up & Installation

Part No. 4005.00.906 3-2

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 3: Set Up & Installation

Part No. 4005.00.906 3-3

3 Set Up & Installation

3.1 Leveling Module

CAUTION:

OPERATION OF THIS MODULE INVOLVES PUMPING OF MOLTEN SOLDER. ALL NORMAL SAFETY

PRACTICES SHOULD BE OBSERVED WITH SPECIAL ATTENTION TO THE FOLLOWING:

SAFETY GLASSES SHOULD BE WORN AT ALL TIMES.

DO NOT MOVE MODULE WHILE SOLDER IS MOLTEN.

DISCONNECT POWER BEFORE SERVICING MODULES.

CAUTION:

LEVELING OF MODULE SHOULD NOT BE ATTEMPTED WITH MOLTEN SOLDER IN THE POT.

Note:

LEVELING IS CRITICAL TO PROVIDE CORRECT SOLDER FLOW.

• Level machine on table.

• Place the level (supplied with tool kit) on Pump Housing (A). Level machine (front to back and

side to side) by adjusting the Leveling Legs.

• After leveling is completed, lock legs with jam nuts.

(A)